Vehicle battery and fuses -> Fuses for Your Skoda Fabia 4 Door Third Generation (2014-2020)

Vehicle battery and fuses › Fuses 125  
Disconnecting the cable  
Jump-starting with the battery of another  
vehicle  
Disconnect the cables in the reverse order from  
connection.  
WARNING  
Risk of injury and danger of vehicle damage!  
Lay the jump start cables so that they cannot be-  
come caught by rotating parts in the engine com-  
partment.  
Fuses  
What you should be mindful of  
NOTICE  
Short circuit!  
NOTICE  
Fire hazard and risk of damage to the electrical sys-  
tem.  
The non-insulated parts of the terminal clamps  
must not touch each other.  
The cable connected to the positive pole of the  
battery must not come into contact with electri-  
cally conductive vehicle parts.  
Do not repair fuses or replace them with stronger  
fuses.  
Replace the defective fuse with a new fuse with  
the same amperage.  
We recommend using replacement fuses from the  
ŠKODA Genuine Accessories range. These guaran-  
tee reliable and safe consumer protection.  
If a newly inserted fuse blows again, seek the help  
of a specialist garage.  
The vehicles must not touch each other.  
Connect the jump start cable  
Connect the terminal clamps of the jump start ca-  
bles in the order shown in the legend.  
One fuse may belong to several consumers. One  
consumer may have several fuses.  
Functionality  
- discharged battery /  
- current-emitting battery  
1
2
3
4
-pole of the discharged battery  
-pole of the current-emitting battery  
-pole of the current-emitting battery  
Earth point of the engine to be started  
Blown fuse  
Conditions for replacing a fuse  
Ignition key removed (vehicle without starter  
button).  
Ignition switched off and driver's door open (vehi-  
cle with starter button).  
All consumers switched off.  
Earth point  
Start the engine  
Start the engine of the current-giving vehicle and  
let it idle.  
Start the engine of the vehicle with the flat battery.  
If the engine of the vehicle with the flat battery  
does not start within 10 seconds, repeat the start-  
ing procedure after approximately 30 seconds.