2007-2013 Audi A5 4 Door Heating and cooling -> Seat heating User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Heating and cooling -> Seat heating for Your Audi A5 4 Door First Generation (2007-2013)

Heating and cooling 113
Controls Safety Driving tips General maintenance Self-help Technical data
Activating a timer
– Press the button.
– Press the control button for AC.
– Select the Timer status and then select the timer you
want to start first.
Three timers are available. This allows you to pre-set different
starting times and running times for the auxiliary heating/ ventila-
tion.
When the time set on one of the timers elapses, the date automati-
cally changes to the next day and the timer status is reset to off.
Each timer first has to be activated before it will switch on the auxil-
iary heating/ventilation at the time you have set.
The timers are not activated automatically. This prevents the auxil-
iary heating/ventilation from switching on repeatedly when the
vehicle is not being used.
Note
Before activating the timer, make sure that the correct time and date
settings have been entered. If the time and/or date are not correct,
the auxiliary heating will come on late or not at all. Please refer to
the MMI Operating Instructions for information on how to set the
date and time.
Applies to vehicles: with auxiliary heating - under development at the time of printing
Setting the running time
– Press the button.
– Press the control button for AC.
– Select Running time and then choose the time.
The running time for the auxiliary heating/ventilation can be set to
a time between 15 and 60 minutes. The auxiliary heating/ventilation
will switch itself off at the end of the programmed running time.
CAR
Fig. 129 MMI display:
Running time
CAR
document_0900452a8179700c.book Seite 113 Donnerstag, 22. März 2007 10:19 10
Heating and cooling114
Applies to vehicles: with auxiliary heating - under development at the time of printing
Remote control
The auxiliary heating and auxiliary ventilation can also be
switched on or off with the remote control.
Switching on
– Press the button for about 2 seconds to activate the
auxiliary heating/ventilation ⇒ fig. 130.
Switching off
– Press the button for about 2 seconds to switch
off the auxiliary heating/ventilation.
Changing the battery
– Push back and remove the battery cover on the remote
control ⇒ fig. 131.
– Change the battery. The diagram in the battery compart-
ment shows how the battery should be fitted. The new
battery must be of the same type as the old battery.
– Re-fit the battery cover.
When it is switched on, the auxiliary heating or auxiliary ventilation
starts immediately and remains on for the period set in the menu.
The maximum running time is 60 minutes.
If you want to switch the system on again after the end of the
programmed running time, press the button .
Transmitter indicator lamp
The transmitter indicator lamp will flash accordingly to show
whether the command you sent via the remote control was
successful.
When you switch the system on by pressing the button the
indicator lamp will flash green for about 30 seconds to confirm that
the heating/ ventilation has been switched on. When you switch the
system off by pressing the button the indicator lamp will
flash red to confirm that the heating/ ventilation has been switched
off.
If the remote control is outside the transmitting range the indicator
lamp will flash red slowly. If there is a fault in the system (e.g. fuel
level is down to reserve), the indicator lamp will flash red rapidly. In
both cases the command will not be executed.
When the remote control battery is almost completely flat, the
transmitter indicator lamp will not light up and no commands will
be executed.
Fig. 130 Remote
control for auxiliary
heating
Fig. 131 Remote
control: Changing
battery
A
1
OFF
A
2
A
1
A
3
A
1
OFF
A
2
document_0900452a8179700c.book Seite 114 Donnerstag, 22. März 2007 10:19 10
Heating and cooling 115
Controls Safety Driving tips General maintenance Self-help Technical data
Transmitting range
The range of the remote control transmitter is about 600 metres.
However, this can be greatly reduced by obstacles (buildings, etc.)
between the remote control transmitter and the vehicle. Hold the
aerial upright when using the remote control.
You should not normally use the remote control at a distance of less
than 3 metres from the vehicle. If you are closer than this, or if you
use the remote control inside the vehicle, this can cause signal over-
load.
For the sake of the environment
Please dispose of old batteries in the proper manner so that they do
not harm the environment.
Seat heating
Applies to vehicles: with front seat heating
Seat heating for front seats
The seat cushions and backrests of the front seats can be
heated electrically.
– Press the button for the seat heating .
– Turn the rotary control to the desired setting.
In setting 0 the seat heating is switched off. Possible settings range
from 1 to 6.
The seat heating setting will be shown on the MMI display
⇒ fig. 132 for a few seconds if the MMI is switched on.
Caution
To avoid damaging the heating elements of the seat heating, please
do not kneel on the seat or apply sharp pressure at a single point.
Applies to vehicles: with seat heating for rear seats
Seat heating for rear seats
The seat cushions and backrests of the two outer rear
seats can be heated electrically.
– Turn the left thumbwheel (on the centre console) to
switch on and regulate the heating for the left rear seat.
– Turn the right thumbwheel (on the centre console) to
switch on and regulate the heating for the right rear seat.
The heating is switched off when the thumbwheel is set to 0.
Possible settings range from 1 to 6.
The heating for the rear seats only operates when a sensor registers
the weight of the occupant in the seat. If nobody is travelling on the
rear seats, please switch off the rear seat heating to avoid activating
it unintentionally.
Caution
To avoid damaging the heating elements of the seat heating, please
do not kneel on the seat or apply sharp pressure at a single point.
A
4
Fig. 132 MMI display:
Seat heating
document_0900452a8179700c.book Seite 115 Donnerstag, 22. März 2007 10:19 10

Related Topics

Heating and cooling
Deluxe automatic air conditioner Deluxe automatic air conditioner - basic settings Deluxe automatic air conditioner plus Deluxe automatic air conditioner plus - basic settings Auxiliary heating and auxiliary ventilation

Popular Owner Manuals

Audi
Audi
BMW
BMW
Citroen
Citroen
Ford
Ford
Honda
Honda
Peugeot
Peugeot