901- Engine Warm-Up Procedure / Engine Start
901 - 2.2 Cooling Down Procedure
1.
Downshift from sixth to first gear, do not apply throttle during this
procedure, with the engine at idle speed (do not activate the clutch)
2.
3.
Select neutral using the clutch
Check reverse gear engages. To select reverse activate the clutch
and press the ‘REVERSE’ switch in the centre console
4.
5.
6.
7.
8.
9.
Select neutral
Allow engine to idle for 2 minutes
Calibrate camshafts if necessary -> see chapter 900 - 1 Software
Check error codes on the display or via RaceCon
Switch off ignition, engine stops
Wait approx. 2 minutes, after check engine oil level, see chapter
100 – 1.2 Engine Lubrication or chapter 901 - 1.2 Checking Engine
Oil Level
10. Check all fluid levels
11. Check the engine for leakage, damage, electrical errors and / or
wiring loom problems
12. Switch off main switch
13. Check the logged data after the warming up procedure, reset the
outing and lap counter if required, calibrate the damper
potentiometers and steering angle sensors, see chapter 900 - 1
Software
Attention
The electronic gearshift prevents shift errors. If a ‘dog to dog’ situation occurs
during the warming up procedure, the ECU initiates an automatic throttle blip.
This is perceived audibly as the engine revs increase shortly. When downshifting
only use the shift paddle without using the clutch or throttle --> the ECU
controls the clutch and throttle.
Version 1 2016-01-01
106 / 113
English 
