Driver information
►
When you finish a lap, the lap time is compared
with the best lap and the difference is indicated
by a or +.
To return to the lap time already started, se-
lect: button > Lap times.
Resetting the lap statistics
Interrupting the lap timer (pause) and
displaying split times
Important: The lap statistics menu must be dis-
played.
►
To pause the lap timer , select Pause from
►
To reset the lap statistics, press the left thumb-
the menu.
wheel until the message No lap times have
been recorded yet. appears.
►
To start the lap timer again, select Resume
from the menu.
►
To display a split time, select Split time from
Note
the menu. The split time appears in the in-
strument cluster for approximately ten sec-
onds. The current lap time continues running in
the meantime.
The lap times for the last 30 laps are shown in
the lap statistics. The fastest and slowest lap
times from up to 99 timed laps are also
shown.
Cancelling lap times
The timing of the current lap is cancelled. The lap
time is deleted and is not included in the statis-
tics.
Acceleration
measurement
Introduction
Applies to: vehicles with acceleration measurement
►
Select Cancel lap from the menu.
Resetting the lap timer
The acceleration measurement function allows
you to time how long it takes you to reach a cer-
tain speed or cover a certain distance. For the
best measurement results, Audi recommends
switching off or restricting the ESC. Please note
that the ambient conditions and tyre characteris-
tics affect the result of the measurement.
►
Select Reset lap times from the menu.
Note
– Up to 99 lap times can be recorded.
– If you interrupt the lap timer to take a
break, you can resume recording later on,
even if you switched off the ignition in the
meantime.
Calling up the acceleration measurement
►
On the instrument cluster, select the vehicle
– Recorded lap times cannot be deleted indi-
vidually from the overall results.
functions tab > button > Acceler. measure-
ment.
– The data recorded in the lap timer remain
stored after the ignition is switched off.
WARNING
Please direct your full attention to the road at
all times. As the driver, you have full responsi-
bility for the safety of the vehicle and other
road users. You should therefore use the ac-
celeration measurement functions on closed
racetracks only – risk of accident!
Lap statistics
Applies to: vehicles with lap timer
Displaying the lap statistics
The number of laps so far , the fastest lap +,
the slowest lap and the average time (avg.) can
be displayed in the instrument cluster.
Note
►
On the instrument cluster, select the vehicle
The acceleration measurement functions
were calibrated with the largest summer
tyre/rim combinations available from the
functions tab > button > Lap statistics.
To show the individual lap times, scroll the left
thumbwheel up/down.
►
184
English 
