2025-2026 Audi S Q5 SUV Assist systems User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Assist systems for Your Audi S Q5 SUV Third Generation (2025-2026)

Trailer towing  
Using the trailer hitch  
Applies to: vehicles with trailer hitch  
To reduce the risk of injury, always remove  
the ball hitch mount if no trailer is mount-  
ed.  
To reduce the risk of an accident, contami-  
nants on the trailer hitch must be removed  
because otherwise the ball hitch mount  
might not be secured correctly in the receiv-  
er.  
Tips  
No ball hitch mount or ball head is provided  
with the trailer hitch. You can purchase  
these at specialty stores.  
Fig. 106 Rear bumper: trailer hitch  
The eyelets on the trailer hitch are only in-  
tended for securing the trailer safety chains.  
The trailer hitch of your vehicle consists of the re-  
ceiver 3 , the trailer socket 1 or retainer for  
1)  
the trailer socket, two eyelets 2 for the safety  
chains, and the receiver cover 4 .  
Driving with a trailer  
Trailer brakes  
The receiver 3 is suitable for securing a remova-  
ble ball hitch mount with a ball head, for exam-  
If the trailer has its own brake system, then fol-  
low the manufacturer specifications. However,  
the brake system on the trailer must never be  
connected to the vehicle brake system.  
ple when towing a trailer ð  
.
In order to use the trailer hitch, pull the cover  
4 out of the receiver 3 in the direction of the  
arrow.  
Safety chains  
Check the receiver 3 for dirt and clean it if nec-  
essary.  
When towing a trailer, use the trailer socket  
1 and secure the safety chains using the eye-  
lets 2 .  
To prevent dirt from entering the receiver 3 ,  
close it with the cover 4 after using it.  
Make sure the safety chains are correctly applied  
when pulling a trailer. The chains should hang  
down enough so that the trailer can drive around  
curves. However, they must not touch the  
ground.  
1)  
WARNING  
WARNING  
If the trailer is equipped with electronic  
brakes, these brakes cannot be activated by a  
factory-installed control system, which in-  
creases the risk of an accident.  
For your own safety, read the installation in-  
structions provided by the ball hitch mount  
manufacturer.  
There is a risk of an accident if the ball hitch  
mount is installed incorrectly. The ball hitch  
Retrofit installation  
mount must be secured in the receiver  
3
correctly. The same applies to accessories  
that are secured in the receiver.  
You can find out if your vehicle is equipped with a  
retrofitted trailer hitch at an authorized Audi  
dealer or authorized Audi Service Facility.  
Only use a ball hitch mount with ball head  
suitable for your vehicle and your trailer.  
1)  
In certain countries.  
137  
Trailer towing  
An authorized Audi dealer or authorized Audi  
Service Facility knows the specifications for retro-  
fitting a trailer hitch and any necessary technical  
requirements.  
WARNING  
Only have the additional trailer hitch instal-  
led by an authorized Audi dealer or author-  
ized Audi Service Facility.  
There is a risk of an accident if the trailer  
hitch is installed incorrectly.  
For your own safety, read the assembly in-  
structions provided by the trailer hitch man-  
ufacturer.  
Note  
Connecting the socket incorrectly could  
cause damage to the vehicle electrical sys-  
tem.  
Longer inclines cannot be driven without a  
suitable cooling system, especially if the  
outside temperatures are high. Otherwise,  
this increases the risk of engine damage.  
138  
Assist systems  
System limitations  
Observe the limitations of the assist systems,  
Assist systems  
General information  
Safety precautions  
sensors, and cameras ð  
.
WARNING  
Observe the safety information for the assist sys-  
The use of an assist system cannot over-  
come the natural laws of physics. A collision  
cannot be prevented in certain circumstan-  
ces.  
tems, sensors, and cameras ð  
.
WARNING  
As the driver, you have complete responsi-  
bility for all driving operations at all times.  
The assist systems cannot replace the driv-  
er's attention. Give your full attention to  
driving the vehicle, and be ready to inter-  
vene in the traffic situation at all times.  
Activate the assist systems only if the sur-  
rounding conditions permit it. Always adapt  
your driving style to the current visual,  
weather, road, and traffic conditions.  
Loose objects can be thrown around the ve-  
hicle interior during sudden driving or brak-  
ing maneuvers, which increases the risk of  
an accident. Store objects securely while  
driving.  
Warnings, messages, or indicator lights may  
not be displayed or initiated on time or cor-  
rectly, for example, if vehicles are approach-  
ing very fast.  
Corrective interventions by the assist sys-  
tems, such as steering or braking interven-  
tions, may not be sufficient or they may not  
occur. Always be ready to intervene.  
Tips  
Due to the system limitations when detect-  
ing the surrounding area, the systems may  
warn or intervene unexpectedly or too late  
in certain situations. The assist systems may  
also interpret a driving maneuver incorrectly  
and then warn or intervene unexpectedly.  
The systems may not function as expected  
in unusual driving situations, such as driving  
offroad, on unpaved roads, on loose ground,  
on inclines, or on grooves in the road.  
The systems may not function correctly in  
unclear traffic situations, such as turn lanes,  
exit ramps, construction zones, rises or dips  
that obstruct visibility, intersections, traffic  
circles, toll booths, or city traffic.  
For the assist systems to be able to respond  
correctly, the function of the sensors and  
cameras must not be restricted. Note the in-  
formation on sensors and cameras  
ðpage 140.  
Tips  
Pay attention to applicable local regulations  
relating to driving tasks, leaving space for  
emergency vehicles, vehicle distance, speed,  
parking location, wheel placement, etc. The  
driver is always responsible for following  
the laws that are applicable in the location  
where the vehicle is being operated.  
The detection of the surrounding area can  
be limited, for example by vehicles traveling  
ahead or by rain, snow, heavy spray, or light  
shining into the camera.  
You can cancel a steering or braking inter-  
vention by the system by braking or acceler-  
ating noticeably, steering, or deactivating  
the respective assist system.  
In trailer mode, some assist systems may be  
limited, may not respond as usual, or may  
be unavailable. Please refer to the instruc-  
tions for towing a trailer located in  
Always check the assist systems settings be-  
fore driving. The settings may have been  
changed, for example by turning off the ig-  
nition or by other persons.  
ðpage 134.  
The steering wheel touch recognition may  
be limited when you wear gloves. Steering  
intervention requests from the steering as-  
sist systems may occur more frequently.  
139  
Assist systems  
If accessories have been mounted on the  
steering wheel, the steering assist systems  
may be limited. The frequency of steering  
intervention requests from the steering as-  
sist systems may vary as well.  
tions. Have an authorized Audi dealer or author-  
ized Audi Service Facility check their function.  
Radar sensors  
Depending on the vehicle equipment, the area in  
front of and behind the vehicle may be detected  
ðfig. 107 1 .  
Surrounding area  
detection  
The wheel sensors on the rear corners of the ve-  
hicle are positioned so that the adjacent lanes to  
the left and right are detected on roads with a  
normal lane width.  
Sensor and camera coverage areas  
Ultrasonic sensors  
Depending on vehicle equipment, various areas  
may be displayed in the MMI using the ultrasonic  
sensors ðfig. 107.  
The range of the displays depends on the location  
of the ultrasonic sensors:  
2
3
4
5
6
Approximately 4 feet (1.20 m)  
Approximately 3 feet (0.90 m)  
Approximately 5.2 feet (1.60 m)  
Approximately 3 feet (0.90 m)  
Approximately 3 feet (0.90 m)  
The side area 6 is detected and evaluated when  
passing. There may have been changes to the sur-  
rounding area after turning off the ignition and  
on again, after opening the doors, or if the vehi-  
cle is left stationary for a period of time. In this  
case, the area will appear black until the area has  
been detected and evaluated.  
Fig. 107 Sensor detection ranges  
Cameras  
Use the camera image in the display to assist you  
only if it shows a good, clear picture. Keep in  
mind that the image in the display is enlarged  
and distorted. Under certain circumstances, ob-  
jects may appear different and unclear in the dis-  
play.  
Fig. 108 Rearview camera coverage area  
The rearview camera can only detect the area  
marked in red ðfig. 108. Only this area is dis-  
The assist systems analyze the data from various  
sensors and cameras installed in the vehicle. Do  
not use any assist systems if there is damage in  
the area of the sensors and cameras or on the ve-  
hicle underbody. Damage can impair the function  
of the sensors and cameras or cause malfunc-  
played on the center display ð  
.
WARNING  
Sensors and cameras have spots in which  
the surrounding area cannot be detected.  
Objects, animals, and people may only be  
140  

Related Topics

Popular Owner Manuals