Checking and Filling
Add the amount of oil shown immediately
ðpage 256.
Have an authorized Audi dealer or authorized
Audi Service Facility repair the malfunction if the
indicator light does not turn off after a few
drives.
Please reduce oil level
There is too much oil in the engine and there is a
risk of damaging the catalytic converter or en-
gine. Drive to an authorized Audi dealer or au-
thorized Audi Service Facility immediately to have
the engine oil level adjusted if necessary. Avoid
high engine speeds, full acceleration, and heavy
engine loads.
WARNING
When the message Please drive to warm
up engine appears, adjust your speed accord-
ing to the weather, road, terrain, and traffic
conditions. You should never disobey the traf-
fic laws applicable in the country in which you
are driving in order to follow driving recom-
mendations.
Oil level sensor: oil change necessary. Please
contact Service
Tips
Fuel has entered the engine oil. This will cause
the engine oil level to rise slowly and the engine
oil quality to decrease. Do not extract engine oil
to reduce the level, because this will increase the
risk of engine damage. Drive to an authorized
Audi dealer or authorized Audi Service Facility im-
mediately to have engine oil extracted.
The oil pressure warning
indicator. Always check the oil level regularly.
is not an oil level
Checking the engine oil level
The engine oil level can be checked in the MMI.
Observe the safety precautions ðpage 250, Gen-
eral information.
Oil level system: malfunction! Please con-
tact Service
►
Park the vehicle on a level surface.
Shut the engine off when it is warm.
Turn only the ignition on again.
Wait approximately five minutes so that the en-
The sensor that checks the engine oil level has
malfunctioned. Drive immediately to an author-
ized Audi dealer or authorized Audi Service Facili-
ty to have the malfunction corrected.
►
►
►
gine oil can flow back into the engine oil pan.
Applies to MMI: Select on the home screen: VE-
HICLE > Settings & Service > Oil level.
Oil pressure sensor: malfunction! Please
►
contact Service
►
The sensor that checks the engine oil pressure
has malfunctioned. Drive immediately to an au-
thorized Audi dealer or authorized Audi Service
Facility to have the malfunction corrected.
Read the oil level in the display. Add engine oil
if the bar in the oil level indicator is just below
“min” ðpage 256.
Note
Please drive to warm up engine
If the engine oil level is too low or too high,
there is a risk of engine damage.
Especially low outside temperatures are a main
reason why fuel may get into the engine oil. The
fuel can only evaporate from the engine oil if the
engine oil temperature is high enough.
Tips
The oil level indicator in the display is only an
informational display. If the oil level is too
low, a minimum oil warning appears in the in-
strument cluster. Add oil and close the hood.
The current oil level will be displayed on the
MMI the next time the ignition is turned on.
Drive in the “S” position.
Drive the engine at higher RPMs while avoiding
full acceleration.
You should drive for at least 30 minutes. The in-
dicator light may not turn off during this time.
Repeat the steps that are described at any time.
255