Appendix
REFERENCE
1. This device may not cause harmful interfer-
ence.
FCC Class B device notice Note: This equip-
ment has been tested and found to comply
with the limits for a Class B digital device, pur-
suant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential in-
stallation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the in-
structions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or televi-
sion reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
2. This device must accept any interference re-
ceived, including interference that may cause
undesired operation.
This radio transmitter has been approved by
the FCC/ISED to operate with the antenna
types listed below with the maximum permissi-
ble gain indicated. Antenna types not included
in this list, having a gain greater than the max-
imum gain indicated for that type, are strictly
prohibited for use with this device.
Interface and frequency range: Bluetooth &
Wifi @ 2.4GHz
Type: ¼ wave coax
Max Gain: -2.5 dBi
Interface and frequency range: Wifi @ 5GHz
Type: ¼ wave coax
–Reorient or relocate the receiving antenna.
–Increase the separation between the equip-
ment and receiver.
Max Gain: -2.8 dBi
This device complies with the FCC/ ISED RF
exposure limits and has been evaluated in
compliance with portable exposure condition.
–Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
The exposure standard for wireless mobile
phones/portable devices employs a unit of
measurement known as the Specific Absorp-
tion Rate, or SAR.
–Consult the dealer or an experienced
radio/TV technician for help.
L’émetteur/récepteur exempt de licence con-
tenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
This device has been shown to be capable of
compliance for localized SAR for uncontrolled
environment/general population exposure lim-
its specified in ANSI/IEEE Std. C95.1-1992 and
has been tested in accordance with the meas-
urement procedures specified in ISED RSS-102
and IEEE Std. 1528- 2013.
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radi-
oélectrique subi, même si le brouillage est sus-
ceptible d’en compromettre le fonctionnement.
The standards include a substantial safety
margin designed to assure the safety of all
persons, regardless of age and health. The
standard incorporates a substantial margin of
safety to give additional protection for the pub-
lic and to account for any variations.
To comply with the measured SAR value/SAR
testing exclusion, the equipment must be in-
stalled and operated with a minimum distance
of 51 mm of the human body.
388
English 
