Lighting and visibility
Never operate the wipers when the
windscreen is dry. Before operating the
wipers when the weather is extremely cold or
hot, check that the wiper blades are not stuck
to the windscreen.
► Left or right: lower or raise the multifunction
control stalk beyond the point of resistance.
Exterior lighting
4
When the ignition is switched on, all the lights
come on (sidelamps, dipped beam headlamps
and number plate lamps).
Three ꢀashes
► Press brieꢁy upwards or downwards (without
going beyond the point of resistance) and the
direction indicators will ꢁash 3 times.
When the ignition is switched oꢀ, all the lights
go out.
Screenwash
In some weather conditions (e.g. low
temperature or humidity), misting on the
internal surface of the glass of the headlamps
and rear lamps is normal, and will disappear
after the lamps have been on for a few
minutes.
Wipers/Screenwash
Wipers
► Pull the wiper control stalk towards you and
hold.
The screenwash operates as long as you hold
the multifunction control stalk, followed by a
cycle of 5 wipes when you release the stalk.
Never look too closely at the light beam
of LED lamps/headlamps: risk of serious
eye injury!
To avoid damaging the wiper blades, do
not operate the screenwash if the
screenwash reservoir is empty.
Only operate the screenwash if there is no
risk of the ꢁuid freezing on the windscreen
and hindering visibility. In winter, use "very
cold climate" rated products.
Direction indicators
► Turn the knob to the desired position:
Continuous wipe
Intermittent wipe
Never top up with water.
Switching oꢀ
To ensure ꢁat-bladed wipers remain
eꢀective:
– Handle them with care.
– Clean them regularly using soapy water.
– Do not use them to hold a piece of
cardboard against the windscreen.
Before operating the wipers in wintry
conditions, clear any snow, ice or frost
from the windscreen, and from around the
wiper arms and blades.
13
English 