Advertisement

Advertisement

Levels for Your Citroen C2 4 Door First Generation (2003-2009)

LEVELS  
REFER TO THE CHAPTER: USER PRECAUTIONS  
Engine oil  
Check the engine oil level  
on horizontal ground with  
the engine having been  
Brake fluid  
The level of fluid should be  
between the marks MIN.  
and MAX. on the reservoir.  
Air filter  
Follow the requirements  
set out in the Maintenance  
Guide.  
A
switched off for at least 10 minutes.  
Quality: See "Maintenance Guide".  
Quality: See "Maintenance Guide".  
If the warning lamp comes on  
while you are driving, stop  
immediately and contact  
CITROËN dealer.  
Windscreen/rear  
screen wash and  
headlamp wash fluid  
a
Use CITROËNꢀapproved  
products wherever possible.  
Capacity: See "Capacities".  
Pull out the manual dipstick.  
Characteristics of fluid  
In order to ensure optimum cleaning  
and to avoid freezing, you must  
never top up or replace this fluid  
with water.  
The level should be  
between the marks MIN.  
and MAX. on the gauge.  
It must never exceed the  
maximum.  
Cabin particle filter/  
Odour filter  
See "Maintenance Guide".  
B
Engine coolant  
The fluid level should be  
betweenthemarksMIN.and  
MAX. on the header tank.  
IV  
Engine hot, wait at least 15 minutes.  
Quality: See "Maintenance Guide".  
Never do anything relating to  
the cooling system of an engine  
that is hot.  
MAX.  
MIN.  
If opening the bonnet when the engine is hot, even if it is  
stopped and the ignition is switched off, remember that the  
cooling fan may operate at any moment.  
12 V battery  
See "Starting with a slave  
battery".  
Consult "User Precautions" at the end of this handbook.  
95  
LEVELS  
Topping up the coolant  
The fluid level should be between  
the marks MIN. and MAX. on the  
header tank.  
Top up the level. If you have to  
put in more than 1 litre, have the  
cooling system checked by a  
CITROËN dealer.  
Engine oil  
Radiator – coolant fluid  
Check the engine oil level on  
horizontal ground with the engine  
having been switched off for at  
least 10 minutes.  
Pull out the manual dipstick.  
The level should be between the  
marks MIN. and MAX. on the  
Checking the level and topping up  
with fluid must always be done with  
the engine cold.  
Engine hot  
Release the protection cover.  
Wait 15 minutes or for the temꢀ  
perature to be lower than 100 °C  
and then carefully unscrew the  
cap so as to allow the pressure to  
drop, protecting yourself with, say,  
a cloth.  
Make sure that the cap is  
back on properly.  
Note: If you need to top up the fluid  
frequently, this indicates a malfunc-  
tion which you should get checked  
at the earliest opportunity.  
IV  
Topping up engine oil  
Before filling, pull out the dipstick.  
Check the dipstick after filling.  
It must never exceed the maxiꢀ  
Quality: See the Maintenance  
Guide.  
Remark: The cooling fan may  
operate for around 10 minutes  
after the engine has stopped.  
Screw the cap back on and close  
the bonnet.  
Quality: See the Maintenance  
Guide.  
If opening the bonnet when the engine is hot, even if it is  
stopped and the ignition is switched off, remember that the  
cooling fan may operate at any moment.  
101