PARKING ASSISTANCE
Operation
When you engage reverse gear,
a sound signal confirms to you that
the system is active. The outline of
your vehicle appears on the screen.
Any obstacles situated to the rear
of your vehicle can be detected.
1
Proximity sensors are located in
the rear bumper of your vehicle.
Remarks:
II
The proximity sensors cannot
detect objects that are
immediately under or over the
bumpers.
A thin object such as a spike,
a bollard or similar, can only
be detected at the start of the
manœuvre but not when the
vehicle arrives close up to it.
In poor weather or in winter,
you need to ensure that the
sensors are not covered with
mud or with ice or snow.
This system in no way replaces
vigilance and responsibility on
the part of the driver.
When you are manœuvring in
reverse gear at a speed of less
than around 10 km/h (approx.
6 mph), they inform you of the pres-
ence of any obstacle located within
their detection zone, by means of:
Activation/Deactivation
You can activate/deactivate the
parking assistance by pressing
button 1. When the parking assisꢁ
tance is inactive, the warning lamp
on button 1 is lit up.
Activation/deactivation of the parking
assistance is memorised when you
stop the vehicle.
Remark: The system is deactivated
automatically if a trailer is attached
to the vehicle.
The fitting of the towbar should
be carried out by the CITROËN
network.
An audible signal emitted by
the rear loudspeakers on the
LH and/or RH side.
Display of the outline of
your vehicle with shading
corresponding to the area
where an obstacle is detected.
As the vehicle approaches the
obstacle,thesoundsignalbecomes
more and more urgent and the
shaded areas are displayed closer
and closer to the vehicle.
When the obstacle is less than
around 25 centimetres from the
vehicle, the sound signal becomes
continuous with display of
a
"WARNING" panel on the screen.
70
English 