Driving
Programming
Operating fault
F
Turn thumb wheel 1 to the "CRUISE"
position: the cruise control mode
is selected but is not switched on
(PAUSE).
In the event of a cruise control malfunction,
the speed is cleared resulting in flashing of the
dashes. Have it checked by a CITRoËn dealer
or a qualified workshop.
F
Set the programmed speed by
accelerating to the required speed, then
press button 2 or 3 (e.g.: 70 mph
(110 km/h)).
You can then change the programmed speed using buttons 2 and 3:
-
-
-
by + or - 1 mph (km/h) = short press,
by + or - 5 mph (km/h) = long press,
in steps of + or - 5 mph (km/h) = maintained press.
When the cruise control is switched on,
be careful if you maintain the pressure
on one of the programmed speed
changing buttons: this may result in a
very rapid change in the speed of your
vehicle.
F
F
Switch off the cruise control by pressing button 4: the screen
confirms that it has been switched off (PAUSE).
Switch the cruise control back on by pressing button 4 again.
do not use the cruise control on
slippery roads or in heavy traffic.
on a steep descent, the cruise control
will not be able to prevent the vehicle
from exceeding the programmed speed.
To avoid any risk of jamming of the
pedals:
Exceeding the programmed speed
9
Intentional or unintentional exceeding of the programmed speed
results in flashing of this speed in the screen.
Return to the programmed speed, by means of intentional or
unintentional deceleration of the vehicle, automatically cancels the
flashing of the speed.
-
ensure that the mat is secured
correctly,
-
never fit one mat on top of another.
Leaving cruise control mode
F
Turn thumb wheel 1 to the "0" position: the cruise control mode is
deselected. The display returns to the distance recorder.
139
English 