Lighting and visibility
Automatic wiping
► Turn the ring to align the desired symbol with
the marking.
Off
– avoid using them to hold cardboard on the
windscreen.
– replace them at the first signs of wear.
Refer to the corresponding section.
Single wipe
Before removing a windscreen wiper blade
Intermittent wipe
► Pull the stalk briefly towards you.
Wash-wipe
Windscreen wash
► Pull the wiper control stalk towards you and
hold.
Reverse gear
When reverse gear is engaged, the rear wiper
will come into operation automatically if the front
windscreen wipers are operating.
The screenwash then the windscreen wipers
operate for a pre-determined time.
► Operating the wiper control stalk within one
minute after switching off the ignition will place
the wiper blades in a vertical position.
The screenwash jets are not adjustable.
Do not handle them (risk of damage).
This function is set via theDriving /
Vehicle touch screen menu.
► Proceed with the desired operation or the
replacement of the wiper blades.
In the event of accumulation of snow or
hard frost or if a bicycle carrier is fitted to
a towing device, deactivate the automatic rear
wiper via the touch screen's Driving/ Vehicle
menu.
To avoid damaging the wiper blades, do
not operate the screenwash if the
screenwash reservoir is empty.
Only operate the screenwash if there is no
risk of the fluid freezing on the windscreen
and hindering visibility. During the winter
period, use "very cold climate" rated products.
Never top up with water.
After refitting a windscreen wiper blade
► To return the wiper blades to their initial
position, switch on the ignition and operate the
wiper control stalk.
Special position of the
windscreen wipers
This maintenance position is used while cleaning
or replacing the wiper blades. It can also be
useful, in wintry weather (ice, snow), to release
the wiper blades from the windscreen.
Automatic windscreen
wipers
In AUTO mode, the windscreen wipers operate
automatically, without any action on the part of
the driver. If rain is detected, the wiping adapts to
the intensity of the rainfall automatically.
Detection of rainfall is by means of a rain/
sunshine sensor at the top centre of the
windscreen, behind the rear view mirror.
Rear wiper
To maintain the effectiveness of the flat
wiper blades, it is advisable to:
– handle them with care.
– clean them regularly using soapy water.
50
English 