Lighting and Visibility
Headlamp dipping
Front foglamps
Exterior lighting control
stalk
4
(Depending on version)
Main lighting
They only work if the sidelamps or
dipped beam headlamps are on.
Turn and align the selection ring to switch
between dipped and main beam headlamps.
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily (“headlamp flash”) by pulling up the
stalk.
Turn the ring to align the symbol with the
marking.
Tip
Lighting off (ignition off)
Sidelamps only
Switching on the lamps after
switching off the ignition
Front foglamps / Rear
foglamp
To reactivate the lighting control, rotate the
ring to the "0" position - lamps off, then to
the desired position.
(Depending on version)
If the driver's door is opened, a temporary
audible signal warns the driver that the
lamps are on.
Dipped or main beam headlamps
They operate with the sidelamps,
dipped or main beam headlamps on.
Tip
In some weather conditions (e.g. low
temperature or humidity), the presence of
misting on the internal surface of the glass
of the headlamps and rear lamps is normal; it
disappears after the lamps have been on for
a few minutes.
45
English 
