Lighting and Visibility
The screenwash and windscreen wipers operate
for as long as the control stalk is pulled.
Termination of the screenwash is followed by a
final wiping cycle.
Electric - eCC21
Knob switch posi- Static loading condi-
Windscreen wipers
4
tion
tion
With Hal- With LED
Warning
ogen
Head-
lamp
Head-
lamp
To avoid damaging the wiper blades,
do not operate the screenwash if the
screenwash reservoir is empty. Only operate
the screenwash if there is no risk of the fluid
freezing on the windscreen and hindering
visibility. During the winter period, use "very
cold climate" rated products. Never top up
with water.
1
2
All the seats occu-
pied + load evenly dis-
tributed in the boot
2
0
Driver + load even-
ly distributed in the
boot
To select the wiping speed: raise or lower the
stalk to the desired position.
Rear wiper
(Depending on version)
Single wiping / Mist
Off
Wiper control stalk
Tip
In wintry conditions, remove snow,
ice or frost present on the windscreen,
around the wiper arms and blades and on
the windscreen seal, before operating the
wipers.
Intermittent wiping
Slow wiping
Warning
Do not operate the wipers on a dry
windscreen. Under extremely hot or cold
conditions, ensure that the wiper blades
are not stuck to the windscreen before
operating the wipers.
Turn the ring to align the desired symbol with
the marking.
Fast wiping
Single wipe
Pull the stalk briefly towards you.
Screenwash-wipe
Off
Front screenwash
Pull the wiper control stalk towards you and
hold.
47
English 