Instruments
During the permitted driving phase
(between 685 and 0 miles (1,100 and 0 km))
You have exceeded the authorised driving
limit: the starting prevention system
inhibits engine starting.
As a safety measure, the driver must
only carry out operations that require
sustained attention with the vehicle
stationary.
Some functions are not accessible when
driving.
To be able to restart the engine, you must call a
CITROËN dealer or a qualified workshop.
If a fault with the SCR system is confirmed
(after 31 miles (50 km) covered with the
permanent display of the message signalling
a fault), these warning lamps come on and the
AdBlue warning lamp flashes, associated with
an audible signal and the display of a message
(e.g. "NO START IN 200 miles" or "Emissions
fault: Starting prevented in 200 miles")
indicating the remaining range expressed in
miles or kilometres.
Recommendations
This screen is of the capacitive type.
Use is possible in all temperatures.
Do not use pointed objects on the touch
screen.
Do not touch the touch screen with wet hands.
Use a soft clean cloth to clean the touch
screen.
Touch screen
The touch screen gives access to:
-
-
the heating/air conditioning controls,
menus for adjusting settings for vehicle
functions and systems,
While driving, the message is displayed every
thirty seconds while the fault with the SCR
emissions control system persists.
The alert is repeated when switching on the
ignition.
You should go to a CITROËN dealer or a
qualified workshop as soon as possible.
Otherwise you will not be able to restart the
vehicle.
-
audio system and telephone controls and
the display of associated information,
and, depending on equipment, allows:
-
the display of alert messages and the visual
parking sensors information,
Touch screen
-
the permanent display of the time and the
exterior temperature (a blue warning lamp
appears when there is a risk of ice),
access to the internet services and
navigation system controls and the display
of associated information.
Use the buttons on each side of the touch
screen to access the menus, then use the
buttons that appear on the touch screen.
Certain functions may be displayed over 1 or
2 pages.
-
Starting prevented
To deactivate/activate a function, press OFF/
ON.
To modify a setting (lighting duration, etc.) or
access additional information, press the symbol
for the function.
Each time the ignition is switched on, these warning
lamps come on and the AdBlue warning lamp
flashes, accompanied by an audible signal and the
display of the message "NO START IN 0 miles" or
"Emissions fault: Starting prevented".
24
English 