Lighting and visibility
Do not operate the wipers on a dry
windscreen. Under extremely hot or cold
conditions, ensure that the wiper blades are
not stuck to the windscreen before operating
the wipers.
0. (Initial adjustment)
4
Driver only or driver + front passenger
-. Driver + front passenger + rear passengers
1. Driver + front passenger + rear passengers +
load in the boot
-. Driver + front passenger + rear passengers +
load in the boot
2. Driver only + maximum authorised load in
the boot
Manual controls
The wipers are controlled directly by the driver.
Switching on / off
This system starts:
– when the corresponding direction indicator is
switched on.
or
Cornering lighting
– from a certain angle of rotation of the steering
wheel.
It becomes inactive:
– below a certain angle of rotation of the
steering wheel.
– above 25 mph (40 km/h).
– when reverse gear is engaged.
Windscreen wipers
To select the wiping speed: raise or lower the
stalk to the desired position.
Activation / Deactivation
If fitted to the vehicle, this system makes use of
the beam from a front foglamp to illuminate the
inside of a bend, when the main or dipped beam
headlamps are on and the vehicle speed is
below 25 mph (40 km/h) (urban driving, winding
road, junctions, parking manoeuvres, etc.).
Fast wiping (heavy rain).
It is set via the Driving / Vehicle touch
screen menu.
Normal wiping (moderate rain).
Wiper control stalk
Intermittent wiping (proportional to the
speed of the vehicle).
In wintry conditions, remove snow, ice or
frost present on the windscreen, around
the wiper arms and blades and the
Off.
Single wipe (press down or pull the stalk
windscreen seal, before operating the wipers.
briefly towards you, then release).
or
45
English 