A N T I - I N T R U S I O N A L A R M
OPERATION OF THE ALARM
Deactivation of volumetric detection
The alarm is able to operate with only perimeter pro-
tection if you deactivate the volumetric protection (if for
example you wish to leave an animal in the vehicle).
To do this, switch off the ignition, then press immedi-
ately on control 1 for at least one second.
The warning lamp 2 should be on permanently. It will
start to flash when the alarm activates.
Arm the alarm by locking your vehicle using the remote
control.
II
First make sure that all the vehicle’s doors are
closed.
The alarm is armed by pressing button A on the remote
control.
When the alarm is armed, the protections become
active within 5 seconds (perimeter) and 45 seconds
(volumetric).
Provided the alarm is armed, any intrusion triggers the
siren for 30 seconds, accompanied by the illumination
of the direction indicators.
The alarm then reverts to armed status, but the deploy-
ment remains memorised and is signalled by the rapid
flashing of the alarm warning lamp 2 when you press
the unlocking button B. The flashing stops when you
switch on the ignition.
The siren is also triggered if there is a cutting of the
electrical supply. To stop it, restore the electrical sup-
ply then give a press on the unlocking button B.
Automatic activation (according to country)
The alarm arms automatically 2 minutes after the boot
or the last door is closed.
In order to prevent the alarm then being triggered
by a door or the boot being opened, it is essential to
press again on the unlocking button B on the remote
control.
Note:
• If you wish to lock your vehicle without arming the
alarm, just lock the vehicle with the key.
• If you try to lock your vehicle when a door or the
boot is still open, the central locking will not oper-
ate, but your alarm becomes armed after approx. 45
seconds.
Note: the siren is automatically disarmed (for example
if you need to disconnect the battery) immediately after
you unlock the vehicle using the remote control.
42
English 