Access
Risk of explosion or leaking of
inflammable liquid or gas!
Do not use in/store in/place in an environment
where the temperature is extremely high or
where the pressure is extremely low due to
very high altitude.
► Switch off the ignition and remove the key
from the ignition switch.
The remote control is now fully operational
again.
Doors
2
Opening
From outside
With Keyless Entry and Start
► After unlocking the vehicle or with the
Do not try to burn, crush or cut a used battery.
"Keyless Entry and Start" system electronic key
in the recognition zone, pull the door handle.
Reinitialising the remote
control
Following replacement of the battery or in
the event of a fault, it may be necessary to
reinitialise the remote control.
From inside
► Pull the interior opening control of a door; this
unlocks the vehicle completely.
With selective unlocking activated:
– Opening the driver's door unlocks
the driver's door only (if the vehicle has not
already been completely unlocked).
– Opening one of the passenger doors
unlocks the rest of the vehicle.
Without Keyless Entry and Start
► Insert the mechanical key (incorporated into
the remote control) into the lock to open the
vehicle.
► Place the electronic key against the back-up
reader on the steering column and hold it there
until the ignition is switched on.
► With a manual gearbox, place the gear lever
in neutral then fully depress the clutch pedal.
► With an automatic gearbox or drive
selector, while in mode P, depress the brake
pedal.
► Switch on the ignition by pressing the
"START/STOP" button.
If the fault persists after reinitialisation, contact a
CITROËN dealer or a qualified workshop without
delay.
► Switch the ignition off.
► Turn the key to position 2 (Ignition on).
► Immediately press the closed padlock button
for a few seconds.
39
English 