Starting and stopping
Key
Take care not to place the key in
contact with grease, dust, rain or a
damp environment.
A heavy object attached to the key (key
ring, ...) weighing down on the shaft
of the key in the ignition switch may
cause a malfunction.
Handbrake
If your vehicle is fitted with a
version with a rotating front seat,
the handbrake can be disengaged.
Pulling the handbrake to immobilise
the vehicle then lowering the lever
does not release the brake, it permits
rotation of the driver's seat.
Pull the button placed at the end of the
handbrake forwards.
The handbrake lever lowers.
You can now rotate the seat.
STARTING AND STOPPING
Good practice when stopping
Minimise engine and gearbox wear
When switching off the ignition, let the
engine run for a few seconds to allow
the turbocharger to return to idle.
Do not press the accelerator when
switching off the ignition.
There is no need to engage a gear
after parking the vehicle.
STOP position: steering lock.
The ignition is off.
Running and accessories position.
Certain accessories can be used.
Starting position.
The starter is operated.
Good practice when starting
Diesel pre-heating warning
light
To return to normal operation, pull the
lever up until it clicks.
Turn the key to the Running
position.
In cold weather, wait for this warning
light to switch off then operate the
starter (Starting position) until the
engine starts.
If the handbrake is on or has
not been released fully, this is
indicated by:
If the temperature is high enough, the
warning light comes on for less than
one second, you can start without
waiting.
-
a warning light which comes
on on the instrument panel,
an audible signal,
-
-
a message on the display.
English 
