227
Driving
Programming
Exiting the speed limiter mode
Turn dial 1 to the "0" position: the speed
Turn dial 1 to the "LIMIT" position: the
speed limiter mode is selected but is not
switched on (Pause).
limiter mode is deselected. It disappears
from the screen.
You do not have to switch the speed limiter on
in order to set the speed.
Operating fault
In the event of a fault with the speed limiter,
the speed is cleared resulting in flashing of the
dashes.
Have it checked by a CITROËN dealer or a
qualified workshop.
Set the speed value by pressing button 2
or 3 (e.g.: 55 mph (90 km/h)).
You can then change the programmed speed using buttons 2 and 3:
-
-
by + or - 1 mph (km/h) = short press,
in steps of + or - 5 mph (km/h) = maintained press.
If speed memorisation is available and activated on your vehicle, the
programmed speed will stop at the closest memorised speed; refer to the
corresponding paragraph.
Switch the speed limiter on by pressing button 4.
Switch the speed limiter off by pressing button 4: the display
confirms that it has been switched off (Pause).
Switch the speed limiter back on by pressing button 4 again.
On a steep descent or in the event of
sharp acceleration, the speed limiter
will not be able to prevent the vehicle
from exceeding the programmed
speed.
Exceeding the programmed speed
Pressing the accelerator pedal to exceed the programmed speed will not have
any effect unless you press the pedal firmly past the point of resistance.
The speed limiter is deactivated temporarily and the programmed speed,
which is still displayed, flashes.
Returning to the programmed speed, by means of intentional or unintentional
deceleration of the vehicle, automatically cancels the flashing of the
programmed speed.
To avoid any risk of jamming of the
pedals:
-
ensure that the mat is positioned
correctly,
-
do not fit one mat on top of another.
English 
