182
11
DS CONNECT RADIO
– Changing the system settings and
configuration.
either by tapping the tab for the desired page, or
by using a finger, sliding the pages to the left or
to the right.
DS CONNECT RADIO
Press in the grey zone to go back up a level or to
confirm.
Press the back arrow to go back a level or confirm.
The system is protected in such a way
that it will only operate in the vehicle.
The Energy Economy Mode message is
displayed when the system is about to enter
the corresponding mode.
The touch screen is of the "capacitive"
type.
To clean the screen, use a soft, non-abrasive
cloth (e.g. spectacles cloth) with no additional
product.
Do not use sharp objects on the screen.
Do not touch the screen with wet hands.
The system’s Open Source Software (OSS)
source codes are available at the
following addresses:
Multimedia audio system
- Applications - Bluetooth®
telephone
Certain information is displayed permanently in
the upper bar of the touch screen:
– Air conditioning status information
(depending on version), and direct access to the
corresponding menu.
– Radio Media and Telephone menu status
information.
– Privacy status information.
– Access to the touch screen and digital
instrument panel settings.
Audio source selection (depending on equipment):
– FM/DAB/AM radio stations (depending on
equipment).
– Telephone connected via Bluetooth and
Bluetooth multimedia broadcast (streaming).
– USB Memory stick.
– Media player connected via the auxiliary socket
(depending on equipment).
First steps
The functions and settings described vary
according to the vehicle version and
configuration.
With the engine running, a press mutes the
sound.
With the ignition off, a press turns the system on.
Increase or decrease the volume using the wheel
or the "plus" or "minus" buttons (depending on
the equipment).
Use the buttons on either side of or below the
touch screen for access to the menus, then press
the virtual buttons in the touch screen.
At all times it is possible to display the rolling
menus by pressing the screen briefly with three
fingers.
For safety reasons and because they
require sustained attention by the driver,
the following operations must be carried out
with the vehicle stationary and the ignition on:
– Pairing the smartphone with the system in
Bluetooth mode.
– Using the smartphone.
– Connection to the CarPlay®, MirrorLinkTM
or Android Auto applications (certain
applications interrupt their display while the
vehicle is moving).
All of the touch areas of the screen are white.
For pages with multiple tabs at the bottom of the
screen, it is possible to switch between pages
English 
