62
04
Lighting and visibility
Do not apply "Rain X" type water-repellent
Do not cover the rain/sunshine sensor.
When using an automatic car wash,
switch off the automatic wipers and the
ignition.
In winter, wait until the windscreen is
completely clear of ice before activating the
automatic wipers.
If the ignition has been off for more than
one minute, the automatic wipers must be
reactivated by pushing the control stalk
downwards.
products.
►ꢀ Unclip the worn wiper blade closest to you and
remove it.
►ꢀ Install the new wiper blade and clip it to the
arm.
►ꢀ Repeat the procedure for the other wiper
blade.
►ꢀ Starting with the wiper blade closest to you,
once again hold each arm by the rigid section,
then guide it carefully onto the windscreen.
Malfunction
If a fault occurs with the automatic wipers, the
wipers operate in intermittent mode.
Have them checked by a dealer or a qualified
workshop.
Switching on
Removing/refitting at the rear
►ꢀ Hold the arm by the rigid section and raise it
as far as possible.
►ꢀ Clean the rear screen using screenwash fluid.
►ꢀ Unclip the worn wiper blade and remove it.
►ꢀ Install the new wiper blade and clip it to the
arm.
►ꢀ Give a short downwards push to the control
stalk.
A wiping cycle confirms that the instruction has
been accepted.
►ꢀ Once again hold the arm by the rigid section,
then guide it carefully onto the rear screen.
This indicator lamp comes on in the
instrument panel, accompanied by a
message.
Automatic windscreen
wipers
In AUTO mode, the windscreen wipers operate
automatically, without any action on the part of
the driver. If rain is detected, the wiping adapts to
the intensity of the rainfall automatically.
Detection of rainfall is by means of a rain/
sunshine sensor at the top centre of the
windscreen, behind the rear view mirror.
Switching off
►ꢀ Give the control stalk another brief push
downwards or place the control stalk in another
position (Int, 1 or 2).
This indicator lamp goes off in the
instrument panel, accompanied by a
message.
English 
