Get COMFORT -> Front seats Guide for DS 5 4 Door First Generation (2011-2018)

Front seats

Manual

1. Adjustments to the height and angle of

the head restraint

To raise it, pull upwards.

To lower it, press on the lug and the head

restraint at the same time.

2. Adjustment of the backrest angle

Turn the wheel to adjust the angle of the

backrest.

3. Adjustment of the seat height

Raise or lower the control lever the number

of times required to obtain the desired

position.

4. Forwards-backwards adjustment of

the seat position

Lift the control bar and slide the seat

forwards or backwards.

5. Adjustment of the driver's lumbar

support

Turn the wheel to obtain the desired level

of lumbar support.

Before moving the seat backwards, ensure that there is nothing that might prevent the full

travel of the seat, so as to avoid the risk of of jamming the seat caused by the presence of

objects on the floor behind the seat or rear passengers. If the seat jams, stop the movement

immediately.

73

Comfort

Electric

1. Adjustment of the seat cushion angle

and height, and forwards-backwards

adjustment

F Raise or lower the front of the control

to adjust the seat cushion angle.

F Raise or lower the rear of the control

to raise or lower the seat.

F Simultaneously raise or lower the

front and rear of the control in order

to raise or lower the entire seat.

2. Adjustment of the backrest angle

Move the control forwards or backwards

to adjust the backrest angle.

3. Adjustment of driver's lumbar

support

Press the control switches to obtain

the desired level of lumbar support.

4. Manual adjustment of the cushion

Pull on the grip to adjust the length of

the cushion.

Before moving the seat backwards, ensure that there is

Switch on the ignition or start the engine if the vehicle has gone into

economy mode.

The electric functions of the driver's seat are active for about 45 seconds

after opening the front door. They are deactivated about 45 seconds after

switching off the ignition and in economy mode.

nothing that might prevent the full travel of the seat, so as to

avoid the risk of of jamming the seat caused by the presence

of objects on the floor behind the seat or rear passengers. If

the seat jams, stop the movement immediately.

To reactivate them, switch on the ignition.

Storing driving positions

Storing a position using

buttons M / 1 / 2

Recalling a stored position

F

Briefly press button 1 or 2 to recall the

F

Switch on the ignition.

corresponding position.

An audible signal indicates the end of the

adjustment.

Adjust your seat and the head-up display.

Press button M, then press button 1 or 2

within four seconds.

An audible signal indicates that the position

has been stored.

Storing a new position cancels the previous

position.

System which stores the electrical settings

of the driver's seat and the head-up display

settings. It enables you to store up to

two positions using the buttons on the side

of the driver's seat.

You can interrupt the current movement

by pressing button M, 1 or 2 or by using

one of the seat controls.

A stored position cannot be recalled

while driving.

Recalling stored positions is

deactivated 45 seconds after switching

off the ignition.

75

Comfort

Head restraint height and

angle adjustment

The head restraint is fitted with a frame

with notches which prevents it from

lowering; this is a safety device in case

of impact.

The adjustment is correct when the

upper edge of the head restraint is

level with the top of the head.

Never drive with the head restraints

removed; they must be in place and

adjusted correctly.

F

To raise a head restraint, pull it upwards.

To remove the head restraint, press the

lug A and pull the head restraint upwards.

To put the head restraint back in place, engage

the head restraint stems in the openings

keeping them in line with the seat back.

To lower the head restraint, press the lug A

and push down on the head restraint at the

same time.

F

To adjust the angle of the head restraint, tilt

its lower part forwards or rearwards.

Heated seats control

Massage function

Activation

F

Press this switch.

Its indicator lamp comes on and the massage

function is activated for a period of 1 hour.

During this time, massage is performed in

6 cycles of 10 minutes (6 minutes of massage

followed by 4 minutes break).

After one hour, the function is deactivated, the

indicator lamp goes off.

F

Use the adjustment wheel to switch on and

select the level of heating required:

This system provides a back massage. It only

operates when the engine is running or in

STOP mode of the Stop & Start system.

0: Off.

deactivation

1: Low.

2: Medium.

3: High.

You can deactivate the massage

function at any time by pressing this

switch, its indicator lamp goes off.

With the engine running, the front seats can be

heated separately.

COMFORT -> Front seats for Your DS 5 4 Door First Generation (2011-2018)

Related Topics

COMFORT

Popular Owner Manuals

Latest Owner Manuals