Advertisement

Advertisement

In Case Of Emergency -> Gear Selector Override for Your Fiat 500 L 4 Door First Generation (2012-2022)

IN CASE OF EMERGENCY 231  
GEAR SELECTOR OVERRIDE  
If a malfunction occurs and the gear selector cannot be  
moved out of the PARK position, you can use the following  
procedure to temporarily move the gear selector:  
1. Turn the engine OFF.  
2. Firmly apply the parking brake.  
3. By pulling the gear selector boot, carefully separate the  
gear selector bezel and boot assembly from the center  
console, and raise it up to access the gear selector  
mechanism.  
7
Release Tab Location  
4. Press and maintain firm pressure on the brake pedal.  
7. Once the key is removed, reinstall the steering column  
cover.  
5. Insert the equipped screwdriver or similar tool into the  
gear selector override access hole (at the right front  
corner of the gear selector assembly) and push and hold  
the override release lever down.  
CAUTION!  
It is advisable to contact an authorized dealer to have  
the reinstall procedure carried out. If you would like to  
proceed in performing the reinstall procedure special  
attention must be paid to the correct coupling of the  
clips. Otherwise damage to the cover or noise might be  
heard due to incorrect fastening of the lower cover.  
NOTE: When inserting the screwdriver, keep it as vertical  
as possible during the override operation.  
6. Move the gear selector to the NEUTRAL position.  
232 IN CASE OF EMERGENCY  
7. The vehicle may then be started in NEUTRAL.  
Then, shift back and forth between DRIVE and REVERSE,  
while gently pressing the accelerator. Use the least amount  
of accelerator pedal pressure that will maintain the rocking  
motion, without spinning the wheels, or racing the engine.  
8. Reinstall the gear selector boot.  
NOTE: Push the ЉESC OffЉ switch, to place the Electronic  
Stability Control (ESC) system in ЉPartial OffЉ mode, before  
rocking the vehicle. Refer to “Electronic Brake Control  
System” in “Safety” for further information. Once the  
vehicle has been freed, push the ЉESC OffЉ switch again to  
restore ЉESC OnЉ mode.  
WARNING!  
Fast spinning tires can be dangerous. Forces generated  
by excessive wheel speeds may cause damage, or even  
failure, of the axle and tires. A tire could explode and  
injure someone. Do not spin your vehicle’s wheels  
faster than 30 mph (48 km/h) or for longer than 30  
seconds continuously without stopping when you are  
stuck and do not let anyone near a spinning wheel, no  
matter what the speed.  
Gear Selector Override  
1 — Raised Gear Selector Boot  
2 — Gear Selector Override Access Hole  
FREEING A STUCK VEHICLE  
If your vehicle becomes stuck in mud, sand or snow, it can  
often be moved using a rocking motion. Turn the steering  
wheel right and left to clear the area around the front  
wheels. Push and hold the lock button on the gear selector.