REPLACING THE REAR
WINDOW WIPER BLADE
Rear window washer
WINDSCREEN /
REAR WINDOW
WIPERS
The rear window washer jets are fixed.
The nozzle holder is located above
the rear window.
Proceed as follows:
raise the cover A fig. 127, undo the
nut B and remove the arm C;
168)
65)
correctly position the new arm, fully
tighten the nut B then lower the cover
A.
WARNING
REPLACING THE
WINDSCREEN WIPER
BLADES
168) Driving with worn windscreen/rear
window wiper blades is a serious hazard,
because visibility is reduced in bad
weather.
raise the wiper arm, press tab A fig.
126 of the attachment spring and
remove the blade from the arm;
fit the new blade, inserting the tab
into the special slot in the arm, making
sure that it is locked;
WARNING
lower the wiper arm onto the
windscreen.
65) Do not operate the windscreen wiper
with the blades lifted from the windscreen.
F1D0101
127
NOZZLES
Windscreen washer
The windscreen washer jets can be
adjusted rotating the side notch with a
screwdriver. If there is no jet of fluid,
firstly check that there is fluid in the
reservoir (see "Checking fluid levels" in
this chapter). Then check that the
nozzle holes are not clogged; use a
needle to unblock them if necessary.
F1D0100
126
142
English 
