position the new arm correctly and
fully tighten nut B fig. 112. Then lower
the cover A fig. 112.
WINDSCREEN/REAR
WINDOW WIPER
WARNING
165)
51)
165) Driving with worn windscreen/rear
window wiper blades is a serious hazard,
because visibility is reduced in bad
weather.
REPLACING THE
WINDSCREEN WIPER
BLADES
raise arm A fig. 111 of the
windscreen wiper, rotate blade B fig.
111 by 90° around pin C and remove
the blade from the pin
WARNING
fit the new blade inserting pin C fig.
111 in the central hole of blade B. Then
rearrange the arm with the blade on
the windscreen.
51) Do not operate the windscreen wiper
with the blades lifted from the windscreen.
F1E0291
112
SPRAY NOZZLES
Windscreen washer: if there is no jet
of fluid, firstly check that there is fluid
in the reservoir. Then check that the
nozzle holes are not clogged; use
a needle to unblock them if necessary.
IMPORTANT In versions with a sun
roof, make sure that the sun roof is
closed before operating the window
washer jets.
F1E0290
111
REPLACING THE REAR
WINDOW WIPER BLADE
Rear window washer: the rear
window washer nozzles are fixed. The
nozzle holder is located above the
rear window.
Proceed as follows:
raise cover A fig. 112, remove the
arm from the vehicle and undo the nut
B that fastens it to the pivot pin;
128
English 
