Get CHANGING A WHEEL Guide for Fiat Scudo Van First Generation (1995-2006)

86

V-5

C H A N G I N G A W H E E L

Tools

Van

The wheel brace and embellisher tool are clipped to the load area bulkhead.

The jack is stowed under the front seat.

3

Combi

The tools are stowed on the right hand rear wheel arch.

➊

➋

Jack

Wheel brace

Wheel embellisher removal tool

1

2

Access to the spare wheel

The spare wheel carrier retaining bolt is located close to the outer edge of the

rear floor.

Slacken the retaining screw using the wheel brace.

Raise the carrier slightly to disengage the retaining hook.

V-5

87

C H A N G I N G A W H E E L

E

Removal

1 - If possible, place the car on firm, level ground. Engage the handbrake firmly.

2 - Wait until the vehicle has reached maximum height then switch off the ignition and engage 1st or reverse gear depen-

ding on the incline.

3 - Position the jack at one of the four jacking points on the underside of the vehicle adjacent to the wheels. Using the

wheel brace, extend the jack until it touches the ground.

4 - To remove the embellisher, pull on one of the holes in the embellisher using the end of the wheel brace.

5 - Extend the jack until the wheel is a few centimetres off the ground.

6 - Unscrew the wheel bolts and remove the wheel.

88

V-5

C H A N G I N G A W H E E L

To refit

1 - Fit the wheel onto the hub, making sure that it is correctly positioned.

2 - Screw in the bolts but do not fully tighten them.

3 - Lower the jack and remove it.

4 - Using the wheel brace, fully tighten the wheel bolts.

5 - Refit the wheel embellisher, aligning the tyre valve aperture with the valve, then pressing it home around its circum-

ference.

6 - Refit the repaired original wheel as soon as possible.

7 - Ensure the tyre pressure is corrrect (see « Tyres ») and have the balance checked.

WARNING

Never get under a jacked up vehicle

unless it is correctly supported by axle stands.

V-5

89

C H A N G I N G A W H E E L

Replacing the spare wheel in the carrier

Slide the spare wheel back into its carrier.

Lift the carrier up and re-engage the retaining hook.

Retighten the screw from inside the load area.

Stow the tools.

Advice

The wheel bolts are specific to the

type of wheel fitted.

If the type of wheel is changed,

check with your dealer that the

wheel bolts are compatible.

The jack is designed specifically for your vehicle,

do not use it for other applications.

Download User Manual App

CHANGING A WHEEL for Your Fiat Scudo Van First Generation (1995-2006)

Popular Owner Manuals

Latest Owner Manuals