Get Dashboard instruments -> Indicators Guide for Fiat Scudo Van Third Generation (2022-2025)

Dashboard instruments

With the automatic gearbox or the drive selector,

it may be necessary to depress the brake pedal

to unlock the gearbox from mode N.

Vehicle ready to drive (Electric)

Fixed, accompanied by an audible signal

when it comes on.

Dipped beam headlamps

Fixed.

The lamps are on.

The vehicle is ready to drive and the thermal

comfort systems are available.

Foot on the clutch

Front foglamps

Fixed.

The indicator lamp goes out upon reaching a

speed of approximately 3 mph (5 km/h) and

lights up again when the vehicle stops moving.

The lamp will go out when you switch oﬀ the

motor and exit the vehicle.

Stop & Start: the change to START mode

is rejected because the clutch pedal is not fully

depressed.

The front foglamps are on.

Blue warning/indicator lamps

Main beam headlamps

Fixed.

Fully depress the clutch pedal.

Green warning/indicator lamps

The lamps are on.

Blind spot monitoring

Fixed.

Automatic wiping

Black/white warning lamps

Fixed.

The function has been activated.

Foot on the brake

Automatic windscreen wiping is activated.

Lane departure warning system

Flashing, accompanied by an audible

signal.

A lane marking has been crossed on the left or

right.

Turn the steering wheel in the opposite direction

to return to the correct trajectory.

For more information, refer to the Driving

section.

Fixed.

Automatic headlamp dipping

Fixed.

The function has been activated

via the vehicle’s conﬁguration menu.

The lighting control stalk is in the "AUTO"

position.

Insuﬃcient or no pressure on the brake

pedal.

With an automatic gearbox, with the engine

running, before releasing the parking brake, to

move out of position P.

For more information, refer to the Lighting and

visibility section.

Indicators

Fixed, accompanied by an onscreen

message.

The system has a fault.

Stop & Start

Fixed.

Service indicator

The service indicator is displayed on the

instrument panel. Depending on the vehicle

version:

When the vehicle stops, the Stop & Start

system puts the engine into STOP mode.

Flashing temporarily.

Stay alert and drive carefully, then carry out (3).

Direction indicators

STOP mode is momentarily unavailable

or START mode is automatically triggered.

For more information, refer to the Driving

section.

Flashing with audible signal.

The direction indicators are on.

– the distance recorder display line indicates

the distance remaining before the next service

is due, or the distance travelled since it was due

preceded by the sign “-”.

Sidelamps

Fixed.

The lamps are on.

16

Dashboard instruments

– an alert message indicates the distance

remaining, as well as the period before the next

service is due or how long it is overdue.

► Press and hold this button.

► Switch on the ignition; the distance recorder

display begins a countdown.

► Release the button when =0 is displayed; the

spanner disappears.

Coolant temperature

indicator (Diesel)

1

Service spanner

On temporarily when the ignition is

switched on.

If you have to disconnect the battery

following this operation, lock the vehicle

and wait at least 5 minutes for the reset to be

registered.

Between 620 and 1,860 miles (1,000 and 3,000

km) remain before the next service is due.

Fixed, when the ignition is switched on.

The next service is due in less than 620

miles (1,000 km).

Retrieving the service information

Have your vehicle serviced very soon.

The service information can be accessed at any

time.

► Press this button.

The service information is displayed for a few

seconds, then disappears.

Service spanner ﬂashing

Flashing then ﬁxed, when the

ignition is switched on.

(With BlueHDi Diesel engines, associated with

the Service warning lamp.)

The servicing interval has been exceeded.

Have your vehicle serviced as soon as possible.

With the engine running:

– In zone A, the temperature is correct.

– In zone B, the temperature is too high.

The associated warning lamp and the

STOP warning lamp light up in red on the

instrument panel, accompanied by the display of

a message and an audible signal.

You must stop the vehicle as soon as it is

safe to do so.

The distance indicated (in miles or

kilometres) is calculated according to the

distance covered and the time elapsed since

the last service.

The alert may be triggered close to a due

date.

Resetting the service indicator

The service indicator must be reset after each

service.

Wait a few minutes before switching oﬀ the

engine.

► Switch the ignition oﬀ.

After switching oﬀ the ignition, carefully

open the bonnet and check the coolant

level.

For more information on Checking

levels, refer to the corresponding

section.

17

Dashboard instruments

Checking

Oil level correct

In the event of a malfunction of the

electric gauge, the oil level is no longer

monitored.

If the system is faulty, you must check the

engine oil level using the manual dipstick

located in the engine compartment.

For more information on Checking levels,

refer to the corresponding section.

After driving for a few minutes, the temperature

and pressure in the cooling system increase.

To top up the level:

► wait at least one hour for the engine to cool,

► unscrew the cap by two turns to allow the

pressure to drop,

This is indicated by a message on the instrument

panel.

► when the pressure has dropped, remove the

cap,

Low oil level

► top up the level to the "MAX" mark.

For more information on Checking levels, refer

to the corresponding section.

AdBlue^®range indicators

(BlueHDi)

The Diesel BlueHDi engines are equipped with

a system that associates the SCR (Selective

Catalytic Reduction) emissions control system

and the Diesel particle ﬁlter (DPF) for the

treatment of exhaust gases. They cannot

function without AdBlue^®ﬂuid.

When the level of AdBlue^®falls below the

reserve level (between 1,500 and 0 miles (2,400

and 0 km)), a warning lamp lights up when

the ignition is switched on and an estimate

of the distance that can be travelled before

engine starting is prevented is displayed in the

instrument panel.

Be aware of the risk of scalding when

topping up the coolant. Do not ﬁll above

the maximum level (indicated on the

reservoir).

This is indicated by a message on the instrument

panel.

If a low oil level is conﬁrmed by a check using

the dipstick, the level must be topped up to avoid

damage to the engine.

Engine oil level indicator

(Depending on version)

On versions ﬁtted with an electric gauge, the

engine oil level status is displayed on the

instrument panel for a few seconds when the

ignition is switched on, at the same time as the

servicing information.

For more information on Checking levels, refer

to the corresponding section.

Oil gauge malfunction

The engine starting prevention system

required by regulations is activated

automatically once the AdBlue^®tank is empty.

It is then no longer possible to start the

engine until the minimum level of AdBlue^®has

been topped up.

The level read will only be correct if the

vehicle is on level ground and the engine

has been oﬀ for more than 30 minutes.

This is indicated by the display of a message on

the instrument panel.

Contact a Fiat Dealership or a qualiﬁed

workshop.

18

Dashboard instruments

Manual display of driving range

With BlueHDi (Euro 6.2/6.3) engines

Malfunction of the SCR emissions

control system

1

While the driving range is greater than

1,500 miles (2,400 km), it is not displayed

automatically.

Warning/

indicator

lamps on

Action

Remaining

range

Malfunction detection

If a malfunction is detected,

these warning lamps come

on, accompanied by an

audible signal and the

display of an "Emissions

control fault" or "NO START

IN" message.

Top up.

Between

1,500 miles

and 500

miles (2,400

km and 800

km)

Top up as

soon as

possible.

Between

500 miles

and 62

miles (800

km and

The alert is triggered while driving when the

fault is detected for the ﬁrst time, and thereafter

when switching on the ignition for subsequent

journeys, for as long as the cause of the fault

persists.

► Press this button to temporarily display the

driving range.

With touch screen

You can view the range information in the

"Driving/Vehicle" menu.

100 km)

If the fault is temporary, the alert

disappears during the next journey, after

self-diagnostic checks of the SCR emissions

control system.

A top-up is

vital, there is

a risk that the

engine will

be prevented

from starting.

Between 62

miles and 0

miles (100

km and 0

km)

Actions required related to a lack of

AdBlue^®

The following warning lamps light up when the

quantity of AdBlue^®is below the reserve level:

driving range of 1,500 miles (2,400 km).

Together with the warning lamps, messages

regularly remind you of the need to top up to

avoid engine starting being prevented. Refer to

the Warning and indicator lamps section for

details of the messages displayed.

Malfunction conﬁrmed during the

permitted driving phase (between 685

miles and 0 miles (1,100 km and 0 km))

To be able

0 miles (km)

If the fault indication is still displayed

permanently after 31 miles (50 km) of driving, the

fault in the SCR system is conﬁrmed.

The AdBlue warning lamp ﬂashes and

a message is displayed ("Emissions

control fault: starting prevented in X miles

(kms)" or "NO START IN X miles (kms)"),

to restart the

engine, add at

least 5 litres of

AdBlue^®to the

tank.

For more information on AdBlue^®

(BlueHDi) and in particular on topping

up, refer to the corresponding section.

19

Dashboard instruments

indicating the driving range in miles or

kilometres.

to the "neutral" position: between ECO and

CHARGE.

Power indicator (Electric)

While driving, the message is displayed every 30

seconds. The alert is repeated when switching

on the ignition.

You can continue driving for up to 685 miles

(1,100 km) before the engine starting

prevention system is triggered.

Charge level indicator

(Electric)

Have it checked by a Fiat Dealership or a

qualiﬁed workshop.

Starting prevented

Every time the ignition is switched on, the

message "Emissions control fault: Starting

prevented" or "NO START IN" is displayed.

CHARGE

Traction battery charging during deceleration

and braking.

ECO

Moderate energy consumption and optimised

driving range.

To restart the engine

Contact a Fiat Dealership or a qualiﬁed

workshop.

The traction battery's actual charge level and

the remaining range are displayed continuously

when the vehicle is started.

POWER

Energy consumption by the drive train during

acceleration.

NEUTRAL

With the ignition oﬀ, opening the driver's

door activates the indicator.

When the ignition is switched on, the vehicle’s

electric drive train neither consumes nor

generates energy; after sweeping over the

indicator, the needle returns to its "neutral"

position: between ECO and CHARGE.

Associated warning lamps

Two successive alert levels indicate that the

energy available has dropped to a low level:

1st level: Reserve

100

The state of charge of the traction battery

is low.

With the ignition oﬀ, opening the driver's

door activates the indicator, which moves

0

%

20

Download User Manual App

Dashboard instruments -> Indicators for Your Fiat Scudo Van Third Generation (2022-2025)

Related Topics

Dashboard instruments

Popular Owner Manuals

Latest Owner Manuals