Maintenance
Note: Make sure that the level is between
Engine severe usage conditions
In case of vehicle severe usage, engine oil
should be changed every 5,000 km or 3
months, whichever occurs first.
the MIN and the MAX marks.
Note: Level measurement will not be
accurate if this procedure is not followed.
1. Make sure that your vehicle is on level
Severe usage conditions:
ground.
•
Short distances (less than 5 km), in
which the engine does not reach
normal operating temperature,
2. If the engine is running turn it off and
wait 15 minutes for the oil to drain into
the oil pan.
3. Remove the dipstick and wipe it with
a clean, lint free cloth. Replace the
dipstick and remove it again to check
the oil level.
•
Frequent usage of vehicle on dusty
roads or in mountain areas,
•
•
Usage in heavy urban traffic,
Usage as driving instructors vehicle,
taxi vehicle, ambulance, military usage
or similar activities,
If the level is at the MIN mark, top up
immediately.
•
Extended usage with contaminated
fuel.
Topping Up
WARNINGS
Oil Consumption
Only top up when the engine is cold.
If the engine is hot, wait 15 minutes
for the engine to cool down.
In the first 5,000 km (run-in period) the oil
consumption is higher, and therefore the
oil level should be checked more
frequently. Maximum acceptable
consumption in this period is one liter. After
the break-in period the engine can
consume up to one liter every 10,000 km.
If the consumption is higher, go to your
Ford Dealer.
Oil consumption also depends on driving
style and vehicle use. Special operating
conditions such as, operating your vehicle
frequently at high speeds, could increase
oil consumption.
Do not remove the filler cap when
the engine is running.
Remove the filler cap.
WARNING
Do not top up further than the MAX
mark.
Note: Oil expands when it is hot. Checking
the oil level when hot will be above the MAX
mark.
Oil Filter
Note: Soak up any spillage with an
The oil filter's function is to filter out
harmful particles without obstructing the
flow of oil to vital parts. Use of oil filters
not meeting Ford specifications could
damage the engine.
absorbent cloth immediately.
Top up with fluid that meets the Ford
specification. See Technical
Specifications (page 140).
Replace the filler cap. Turn it until you feel
a strong resistance.
118
Ecosport (CBW) India
English 
