Get Lights -> Bulb replacement Guide for Ford Edge SUV First Generation (2007-2014)

Map/dome lamp (if equipped)

The dome lamp lights when:

• any door is opened,

• the instrument panel dimmer

switch is rotated up until the

courtesy lamps come on, and

• any of the remote entry controls

are pressed and the ignition is

off.

The map lamps are activated by pressing the controls on either side of

the lens.

Rear courtesy lamp

Located in the rear cargo area, the

courtesy lamp lights when:

• any door is opened.

• any of the remote entry controls

are pressed and the ignition is

off.

BULB REPLACEMENT

Lamp assembly condensation

Exterior lamps are vented to accommodate normal changes in pressure.

Condensation can be a natural by-product of this design. When moist air

enters the lamp assembly through the vents, there is a possibility that

condensation can occur when the temperature is cold. When normal

condensation occurs, a thin film of mist can form on the interior of the

lens. The thin mist eventually clears and exits through the vents during

normal operation. Clearing time may take as long as 48 hours under dry

weather conditions.

Examples of acceptable condensation are:

• Presence of thin mist (no streaks, drip marks or droplets)

• Fine mist covers less than 50% of the lens

Examples of unacceptable moisture (usually caused by a lamp water

leak) are:

• Water puddle inside the lamp

Lights

2010 Edge (edg)

Owners Guide, 3rd Printing

USA (fus)

• Large water droplets, drip marks or streaks present on the interior of

the lens

Take your vehicle to dealer for service if any of the above conditions of

unacceptable moisture are present.

Using the right bulbs

Replacement bulbs are specified in the chart below. Headlamp bulbs

must be marked with an authorized “D.O.T.” for North America and an

“E” for Europe to ensure lamp performance, light brightness and pattern

and safe visibility. The correct bulbs will not damage the lamp assembly

or void the lamp assembly warranty and will provide quality bulb burn

time.

Function Number of bulbs

Trade

number

Headlamp high beam 2 9005

Headlamp low beam 2 H11

Front park/turn signal

lamp

3157NAK

(amber)

Rear sidemarker lamp 2 194

Stop/tail/turn lamp 2

3157K LCP

or 3157K

Backup lamp 2 921

License plate lamp 2 168

* High-mount brake lamp N/A LED

Fog lamp (if equipped) 2 H11

Map lamp 2 W5W

Second row dome/reading

lamp

3 578

Rear courtesy lamp 1 578

Visor vanity lamp - Slide

on Rod system (SOR) (if

equipped)

237

All replacement bulbs are clear in color except where noted.

To replace all instrument panel lights - see your authorized dealer.

* To replace these lamps - see your authorized dealer.

Lights

2010 Edge (edg)

Owners Guide, 3rd Printing

USA (fus)

Replacing interior bulbs

Check the operation of all bulbs frequently.

Replacing headlamp bulbs

Check the operation of all bulbs frequently.

1. Make sure that the headlamp control is in the off position.

2. Open the hood.

3. Remove the bulb cover.

4. Turn the bulb holder

counterclockwise and remove it.

5. Disconnect the electrical

connector.

Lights

2010 Edge (edg)

Owners Guide, 3rd Printing

USA (fus)

WARNING: Handle a halogen headlamp bulb carefully and keep

out of children’s reach. Grasp the bulb only by its plastic base

and do not touch the glass. The oil from your hand could cause the

bulb to break the next time the headlamps are operated.

6. Reverse the procedure to install the new bulb.

Replacing front parking lamp/turn signal bulbs

1. Make sure that the headlamp control is in the off position.

2. Open the hood.

3. Reach over the front bolster.

4. Rotate the bulb socket

counterclockwise and remove from

the lamp assembly.

5. Carefully pull the bulb out of the

socket and push in the new bulb.

6. Install the bulb socket into the

lamp assembly and rotate clockwise.

Lights

2010 Edge (edg)

Owners Guide, 3rd Printing

USA (fus)

Replacing tail/stop/turn/sidemarker/backup lamp bulbs

The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same

area of the tail lamp assembly, one below the other. Follow the same

steps to replace these bulbs:

1. Make sure the headlamp switch is

in the off position, then open the

liftgate to expose the lamp assembly

bolts.

2. Remove the two bolts from the

lamp assembly.

3. Carefully remove the lamp

assembly away from the vehicle by

pulling the assembly straight out to

expose the bulb socket.

4. Rotate the bulb socket counterclockwise and remove from lamp

assembly.

5. Pull bulb straight out of socket and snap in the new bulb.

6. Install the bulb socket into the lamp assembly and rotate clockwise.

7. Carefully install the tail lamp assembly on the vehicle by securing the

lamp assembly with two bolts.

Replacing high-mount brake lamp bulbs

Your vehicle is equipped with an LED center high-mount stop lamp. It is

designed to last the life of the vehicle. If replacement is required, see

your authorized dealer.

Replacing license plate lamp bulbs

1. Make sure the headlamp switch is

in the off position.

2. Press the lever and carefully pry

the license plate lamp assembly

(located above the license plate)

from the liftgate.

3. Rotate the bulb socket

counterclockwise and remove from

lamp assembly.

Lights

2010 Edge (edg)

Owners Guide, 3rd Printing

USA (fus)

4. Pull bulb straight out of socket

and push in the new bulb.

5. Install the bulb socket into the

lamp assembly and rotate clockwise.

6. To install, carefully press the

lamp assembly into the liftgate.

Replacing fog lamp bulbs (if equipped)

1. Make sure the fog lamp switch is

in the off position.

2. From underneath the vehicle,

remove the splash shield and rotate

the harness/bulb assembly

counterclockwise, to remove from

the fog lamp.

3. Carefully disconnect the bulb

from the harness assembly via the two snap clips.

Install the new bulb in reverse order.

Lights

2010 Edge (edg)

Owners Guide, 3rd Printing

USA (fus)

Lights -> Bulb replacement for Your Ford Edge SUV First Generation (2007-2014)

Related Topics

Popular Owner Manuals

Latest Owner Manuals