Get Capacities and Specifications Guide for Ford Edge SUV Third Generation (2024-2026)

WARNING: Do not get under a

vehicle that is supported by a jack.

WARNING: Do not attempt to

change a tire on the side of the vehicle

close to moving traffic. Pull far enough

off the road to avoid the danger of being

hit when operating the jack or changing

the wheel.

WARNING: Use only the specified

jacking points. If you use other locations,

you could damage the body, steering,

suspension, engine, braking system or

the fuel lines.

WARNING: Always use the jack

provided as original equipment with your

vehicle. If using a jack other than the one

provided, make sure the jack capacity is

adequate for the vehicle weight,

including any vehicle cargo or

modifications. If you are unsure if the jack

capacity is adequate, contact the

authorized dealer.

WARNING: The jack supplied with

this vehicle is only intended for changing

wheels. Do not use the vehicle jack other

than when you are changing a wheel in

an emergency.

WARNING: Make sure there is no

grease or oil on the threads or the

surface between the wheel lugs and

nuts. This can cause the lug nuts to

loosen while driving.

E166722

Note: The jack does not require

maintenance or additional lubrication over

the service life of your vehicle.

Note: Passengers should not remain in your

vehicle when the vehicle is being jacked.

1. Park on a level surface, set the parking

brake and activate the hazard flashers.

2. Place the transmission in park (P) and

turn the engine off.

E175447

3. Block both the front and rear of the

wheel diagonally opposite the flat tire.

For example, if the left front tire is flat,

block the right rear wheel.

4. Lift and remove the carpeted load floor

panel to access the minispare and jack

kit.

5. Remove the wing nut securing the

spare tire by turning it

counterclockwise.

6. Remove the spare tire and jack kit from

the spare tire compartment.

343

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Changing a Road Wheel (If Equipped)

E178186

7. Remove plastic wing nut and jack and

lug wrench assembly.

8. Detach the lug wrench from the jack

by turning the jack hex nut drive screw

counterclockwise. This will lower the

jack and loosen the mechanical lock.

E294117

9. Unfold the wrench for use.

E181744

10. If your vehicle has wheel trim covering

the lug nuts, use the tool provided

with the jack assembly to remove the

wheel trim.

E294584

11. Loosen each wheel lug nut one-half

turn counterclockwise, but do not

remove them until the wheel is raised

off the ground.

12. If your vehicle has a warning triangle

and you are jacking the vehicle on the

roadside shoulder, set the warning

triangle upright on the shoulder of the

road facing the direction of oncoming

traffic.

E336095

13. Arrows depict vehicle jacking points

on the underside of the vehicle at the

locations shown above. The warning

label on the jack depicts the details.

14. Find the arrows embossed on the

vehicle downward flange next to the

tire you are changing.

15. Position the jack so that the vehicle

downward flange rests in the jack

saddle flange between the arrows,

as shown above. Raise the vehicle by

using the lug wrench to turn the jack

nut clockwise. Once the flat tire is off

the ground, remove the lug nuts with

the lug wrench.

344

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Changing a Road Wheel (If Equipped)

16. Replace the flat tire with the spare

tire, making sure the valve stem is

facing outward. Reinstall the lug nuts

until the wheel is snug against the

hub. Do not fully tighten the lug nuts

until the wheel has been lowered.

17. Lower the wheel by turning the jack

handle counterclockwise.

18. Remove the jack and fully tighten the

lug nuts in the order shown. See

Wheel Nuts (page 346).

E306781

19. To store the jack kit, fold the jack

wrench handle and engage it to the

bracket of the jack base using the lug

wrench pin. Swing the wrench

upwards, adjust the jack height until

the wrench hook engages to the hole

on the jack. Turn the hex nut

clockwise by hand until secure.

Re-position the jack kit assembly into

the original vehicle position and

secure with the plastic wing nut. Make

sure the jack is fastened securely

before you drive.

E294121

20. Unblock the wheel and retrieve the

warning triangle.

Stowing the flat tire

You cannot store the full-sized road wheel

in the temporary spare tire well.

1. Find the flat tire retainer strap tucked

inside the jack channel. Lower the

carpeted load floor.

2. Stow the flat tire in the cargo area on

the load floor with the wheel facing up.

Secure the flat tire with the retainer

strap by following the next steps.

E142906

3. Locate the rear left side and right side

cargo tie-down rings. Push the loop end

of the retainer strap through one cargo

tie-down ring. Thread the non-loop end

through the loop.

4. Weave the retainer strap through the

wheel openings.

345

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Changing a Road Wheel (If Equipped)

5. Locate the cargo tie-down in the

opposite rear corner of the cargo area.

Thread the retainer strap though the

tie-down and pull tight.

6. Secure the flat tire by tying a 2-half

hitch knot.

E143746

WHEEL NUTS

WARNING: When you install a

wheel, always remove any corrosion, dirt

or foreign materials present on the

mounting surfaces of the wheel or the

surface of the wheel hub, brake drum or

brake disc that contacts the wheel. Make

sure to secure any fasteners that attach

the rotor to the hub so they do not

interfere with the mounting surfaces of

the wheel. Installing wheels without

correct metal-to-metal contact at the

wheel mounting surfaces can cause the

wheel nuts to loosen and the wheel to

come off while your vehicle is in motion,

resulting in loss of vehicle control,

personal injury or death.

(Nm)

Bolt Size

162 (220 Nm)M14 x 1.5

Torque specifications are for nut and bolt

threads free of dirt and rust. Use only our

recommended replacement wheel nuts

and or wheel bolts.

Retighten the wheel nuts to the specified

torque within 100 mi (160 km) after any

wheel disturbance, such as tire rotation,

changing a flat tire or wheel removal.

E145950

Hub pilot bore.A

Inspect the wheel pilot hole and

mounting surface prior to installation.

Remove any visible corrosion or loose

particles.

346

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Changing a Road Wheel (If Equipped)

ENGINE SPECIFICATIONS - 2.0L ECOBOOST™

SpecificationEngine

10.0:1Compression ratio.

122 in³ (2,000 cm³)Displacement.

1-3-4-2Firing order.

Coil on plugIgnition system.

Minimum 87 octaneRequired fuel.

0.028 in (0.7 mm) - 0.031 in (0.8 mm)Spark plug gap.

347

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Capacities and Specifications

ENGINE SPECIFICATIONS - 2.7L ECOBOOST™

SpecificationEngine

10.0:1Compression ratio.

165 in³ (2,700 cm³)Displacement.

1-4-2-5-3-6Firing order.

Coil on plugIgnition system.

Minimum 87 octaneRequired fuel.

0.028 in (0.7 mm) - 0.031 in (0.8 mm)Spark plug gap.

348

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Capacities and Specifications

MOTORCRAFT PARTS - 2.0L ECOBOOST™

Motorcraft Part NumberComponent

FA-1912AAir filter element.

BAGM-48H6-760

Battery.

FP-71ACabin air filter.

FP-80 (odor)Cabin air filter.

FL-910-S

Engine oil filter.

SP-594Spark plug.

WW-2755-A (driver side)Windshield wiper blade.

WW-2760-A (passenger side)

WW-1414-A (rear window)

The design of this Motorcraft part is for vehicles with Automatic-Start-Stop.

If a Motorcraft oil filter is not available, use an oil filter that aligns to SAE/USCAR – 36

Performance Specifications. Filter Type B.

We recommend Motorcraft parts that are available at your authorized dealer or at

www.fordparts.com. We engineer these parts for your vehicle to meet or exceed our

specifications. Use of other parts could impact vehicle performance, emissions and

durability. Your warranty could be void for any damage related to use of other parts.

349

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Capacities and Specifications

MOTORCRAFT PARTS - 2.7L ECOBOOST™

Motorcraft Part NumberComponent

FA-1912AAir filter element.

BAGM-48H6-760Battery.

FP-71ACabin air filter.

FL-2062AEngine oil filter.

SP-594Spark plug.

WW-2755-A (driver side)Windshield wiper blade.

WW-2760-A (passenger side)

WW-1414-A (rear window)

We recommend Motorcraft parts that are available at your authorized dealer or at

www.fordparts.com. We engineer these parts for your vehicle to meet or exceed our

specifications. Use of other parts could impact vehicle performance, emissions and

durability. Your warranty could be void for any damage related to use of other parts.

350

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Capacities and Specifications

ENGINE OIL CAPACITY AND

SPECIFICATION - 2.0L

ECOBOOST™

Use oil that meets the defined

specification and viscosity grade.

If you do not use oil that meets the defined

specification and viscosity grade, it could

result in:

• Component damage that your vehicle

warranty does not cover.

• Longer engine cranking periods.

• Increased emission levels.

• Reduced vehicle performance.

• Reduced fuel economy.

E142732

An oil that displays this symbol conforms

to current engine, emission system and

fuel economy performance standards of

ILSAC.

We recommend Motorcraft motor oil for

your vehicle. If Motorcraft oil is not

available, use motor oils of the

recommended viscosity grade that display

the API Certification Mark for gasoline

engines.

Do not use supplemental engine oil

additives because they are unnecessary

and could lead to engine damage that your

vehicle warranty does not cover.

Capacities

Including the Oil FilterVariant

5.5 qt (5.2 L)All.

Materials

SpecificationName

WSS-M2C961-A1Motorcraft® SAE 5W-30 Motor Oil(U.S.)

Motorcraft® SAE 5W-30 Motor Oil / Huile moteur

SAE 5W-30 Motorcraft®(Canada)

XO-5W30-Q1SP, XO-5W30-Q1FS(U.S.)

CXO-5W30-LSP6, CXO-5W30-LFS6(Canada)

351

2024 Edge (CDQ) Canada/United States of America, enUSA, Edition date: 202306, DOM

Capacities and Specifications

Capacities and Specifications for Your Ford Edge SUV Third Generation (2024-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals