Wipers and Washers
Note: If streaks or smears appear on the
windshield, clean the windshield and the
wiper blades. If that does not resolve the
issue, install new wiper blades.
Note: If you switch autolamps and
autowipers on, the headlamps turn on when
the windshield wipers continuously operate.
Autowipers Settings
Autowipers defaults to on and remains on
until you switch it off in the information
display. When you switch off autowipers,
the wipers operate in intermittent mode.
E295997
A
B
C
High sensitivity.
Autowipers On.
Low sensitivity.
WINDSHIELD WASHERS
Use the rotary control to adjust the
sensitivity of the autowipers. When you
select low sensitivity, the wipers operate
when the sensor detects a large amount
of water on the windshield. When you
select high sensitivity, the wipers operate
when the sensor detects a small amount
of water on the windshield.
Keep the outside of the windshield clean.
The rain sensor is very sensitive and the
wipers may operate if dirt, mist or insects
hit the windshield.
E242323
Pull the lever toward you to
operate the windshield washers.
In these conditions, you can do the
E270967
following:
When you release the lever, the wipers
operate for a short time. When activated,
a courtesy wipe occurs a short time after
the wipers stop to clear any remaining
washer fluid.
Note: You can switch courtesy wipe on or
off in the touchscreen. See Settings (page
464).
•
Lower the sensitivity of the autowipers
to reduce the amount of smearing on
the windshield.
•
•
Switch to normal or high-speed wipe.
Switch autowipers off.
Note: Fully defrost the windshield before
you switch the windshield wipers on.
Note: Do not operate the washers when
the washer reservoir is empty. This could
cause the washer pump to overheat.
Note: Make sure that you switch the
windshield wipers off before entering a car
wash.
85
Explorer (CTW), enUSA, Edition date: 202007, Second-Printing
