Cruise Control(If Equipped)
Note: Cruise control will disengage if your
PRINCIPLE OF OPERATION
vehicle speed decreases more than 10 mph
(16 km/h) below your set speed while
driving uphill.
WARNING
The system does not relieve you of
your responsibility to drive with due
care and attention.
Switching Cruise Control On
Press and release ON.
The warning indicator will
display in the instrument cluster.
Cruise control allows you to control your
speed using the switches on the steering
wheel. You can use cruise control when
you exceed approximately 20 mph (30
km/h).
E71340
Setting the Cruise Speed
1. Accelerate to the desired speed.
2. Press and release SET+.
USING CRUISE CONTROL
3. Take your foot off the accelerator
pedal.
WARNINGS
Do not use cruise control on winding
roads, in heavy traffic or when the
road surface is slippery. This could
result in loss of vehicle control, serious
injury or death.
Changing the Set Speed
•
•
•
Press and hold SET+ or SET-. Release
the control when you reach the desired
speed.
When you are going downhill, your
speed may increase above the set
Press and release SET+ or SET-. The
set speed will change in approximately
1 mph (2 km/h) increments.
speed. The system will not apply the
brakes. Change down a gear to assist the
system in maintaining the set speed.
Failure to do so could result in loss of
vehicle control, serious injury or death.
Press the accelerator or brake pedal
until you reach the desired speed. Press
and release SET+.
Canceling the Set Speed
Press and release CAN, or tap the brake
pedal. The set speed will not be erased.
Note: For vehicles with manual
transmission, depressing the clutch pedal
will also cancel the set speed.
Resuming the Set Speed
Press and release RES.
Switching Cruise Control Off
E102679
Press and release OFF or switch the
ignition off.
The cruise controls are located on the
steering wheel.
139
Fiesta (CCT), enUSA, Second Printing
English 
