Security
You must have two previously
Programming a Spare Intelligent
Access Key
programmed coded keys and the new
unprogrammed key readily accessible. See
your authorized dealer to have the spare
key programmed if two previously
See your authorized dealer to have
additional keys programmed to your
vehicle.
programmed coded keys are not available.
Read and understand the entire procedure
before you begin.
ANTI-THEFT ALARM
Alarm System
1. Insert the first previously programmed
coded key into the ignition.
The perimeter alarm is a deterrent against
unauthorized access to your vehicle
through the doors and the hood. It also
protects the audio unit.
2. Switch the ignition from off to on. Keep
the ignition on for at least three
seconds, but no more than 10 seconds.
3. Switch the ignition off and remove the
first coded key from the ignition.
Triggering the Alarm
4. After three seconds but within 10
seconds of switching the ignition off,
insert the second previously coded key
into the ignition.
Once armed, the alarm is triggered in any
of the following ways:
•
If someone opens a door, the liftgate
or the hood without a valid key or
remote control.
5. Switch the ignition from off to on. Keep
the ignition on for at least three
•
•
If someone removes the audio or
navigation system.
seconds, but no more than 10 seconds.
6. Switch the ignition off and remove the
second previously programmed coded
key from the ignition.
If you switch the ignition on without a
valid key.
7. After three seconds but within 10
seconds of switching the ignition off
and removing the previously
If the alarm is triggered, the alarm horn will
sound for 30 seconds and the hazard
warning flasher will flash for five minutes.
programmed coded key, insert the new
unprogrammed key into the ignition.
Any further attempts to perform one of the
above will trigger the alarm again.
8. Switch the ignition from off to on. Keep
the ignition on for at least six seconds.
Arming the Alarm
9. Remove the newly programmed coded
key from the ignition.
To arm the alarm, lock your vehicle. See
Locks (page 51).
If the key has been successfully
programmed it will start the engine and
operate the remote entry system (if the
new key is an integrated keyhead
transmitter).
Disarming the Alarm
Vehicles Without Keyless Entry
Disarm and silence the alarm by unlocking
the doors with the key and switching the
ignition on with a correctly coded key or
unlocking the doors with the remote
control.
If programming was not successful, wait
10 seconds and repeat Steps 1 through 8.
If you are still unsuccessful, take your
vehicle to your authorized dealer.
59
Fiesta (CCT), enUSA, Second Printing
English 
