Get Keys and Remote Controls -> Remote Control Guide for Ford Focus 4 Door Third generation(2010-2017)

Keys and Remote Controls

Note: The remote control contains sensitive

GENERAL INFORMATION ON

RADIO FREQUENCIES

electrical components. Exposure to moisture

or impact may cause permanent damage.

This device complies with Part 15 of the

FCC Rules and with Industry Canada

license-exempt RSS standard(s).

Operation is subject to the following two

conditions: (1) This device may not cause

harmful interference, and (2) This device

must accept any interference received,

including interference that may cause

undesired operation.

REMOTECONTROL-VEHICLES

WITH: KEYLESS ENTRY

Intelligent Access Key

Note: Changes or modifications not

expressively approved by the party

responsible for compliance could void the

user's authority to operate the equipment.

The term IC before the radio certification

number only signifies that Industry Canada

technical specifications were met.

The typical operating range for your

transmitter is approximately 33 feet (10

meters). Vehicles with the remote start

feature will have a greater range. One of

the following could cause a decrease in

operating range:

E162192

Key Blade

The intelligent access key also contains a

removable key blade that you can use to

unlock your vehicle.

•

weather conditions

nearby radio towers

structures around the vehicle

2

other vehicles parked next to your

vehicle

The radio frequency used by your remote

control can also be used by other short

distance radio transmissions, for example

amateur radios, medical equipment,

wireless headphones, remote controls and

alarm systems. If the frequencies are

jammed, you will not be able to use your

remote control. You can lock and unlock

the doors with the key.

1

Note: Make sure to lock your vehicle before

leaving it unattended.

Note: If you are in range, the remote control

will operate if you press any button

unintentionally.

1

E87964

47

Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing

Keys and Remote Controls

To release the key blade:

1. Press and hold the buttons on the

edges of the transmitter to release the

cover. Carefully remove the cover.

3

2. Remove the key blade.

Programming a New Remote

Control

To program an additional remote control

See Security (page 67).

E105362

Changing the Remote Control

Battery

3. Use a suitable tool, for example a

screwdriver, to carefully seperate the

two halves of the remote control.

The remote control uses one coin-type

three-volt lithium battery CR2032 or

equivalent.

Make sure that you dispose of

old batteries in an

E107998

environmentally friendly way.

Seek advice from your local authority

about recycling old batteries.

2

4

E119190

1

4. Twist the screwdriver in the position

shown to separate the two halves of

the remote control.

1

E87964

1. Press and hold the buttons on the

edges of the transmitter to release the

cover. Carefully remove the cover.

2. Remove the key blade.

48

Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing

Keys and Remote Controls

REMOTECONTROL-VEHICLES

5

WITH: INTEGRATED KEY

TRANSMITTER

Integrated Keyhead Transmitter(If

Equipped)

E125860

Note: Do not touch the battery contacts or

the printed circuit board with the

screwdriver.

5. Carefully remove the battery with the

E142585

screwdriver.

Use the key blade to start your vehicle and

unlock or lock the driver door from outside

your vehicle. The buttons on the key

operate the remote control.

6. Install a new battery with the + facing

downward.

7. Assemble the two halves of the remote

control.

8. Reinstall the key blade.

Note: Do not wipe off any grease on the

battery terminals or on the back surface of

the circuit board.

Note: Replacing the battery does not delete

the transmitter from the vehicle. The

transmitter should operate normally.

Locating Your Vehicle

Press the lock button on the key twice

within three seconds. The horn may sound

and the direction indicators flash.

E138615

Note: Your vehicle keys came with a

security label that provides important key

cut information. Keep the label in a safe

place for future reference.

The horn may sound twice and the

direction indicators do not flash if:

•

Locking was not successful.

Any door or the liftgate is open.

Programming a New Remote

The hood is open on vehicles with an

Control

anti-theft alarm or remote start.

To program an additional remote control

See Security (page 67).

49

Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing

Keys and Remote Controls

Reprogramming the Unlocking

Function

Note: When you press the unlock button,

either all the doors are unlocked or only the

driver door is unlocked. Pressing the unlock

button again unlocks all the doors.

Press and hold the unlock and lock buttons

on the remote control simultaneously for

at least four seconds with the ignition off.

The direction indicators flash twice to

confirm the change.

E138620

3. Insert the new battery. Refer to the

symbols inside the transmitter for the

correct orientation of the battery.

Press the battery down to make sure

it is fully in the housing.

To return to the original unlocking function,

repeat the process.

4. Reinstall the battery housing cover

Changing the Remote Control

Battery

The remote control uses one coin-type

three-volt lithium battery CR2032 or

equivalent.

onto the transmitter.

Note: Do not wipe off any grease on the

battery terminals or on the back surface of

the circuit board.

Note: Replacing the battery does not erase

Make sure that you dispose of

the programmed key from your vehicle.

old batteries in an

E107998

environmentally friendly way.

Locating Your Vehicle

Seek advice from your local authority

about recycling old batteries.

Press the lock button on the key twice

within three seconds. The horn sounds and

the direction indicators flash. We

recommend you use this method to locate

your vehicle, rather than using the panic

alarm.

The horn sounds twice and the direction

indicators do not flash if:

•

Locking was not successful.

Any door or the liftgate is open.

The hood is open on vehicles with an

anti-theft alarm or remote start.

E138619

Sounding the Panic Alarm(IfEquipped)

1. Twist a thin coin in the slot of the

transmitter near the key ring to remove

the battery cover.

Press the button to sound the

panic alarm. Press the button

E138624

again or switch the ignition on to

2. Remove the old battery.

silence it.

Note: The panic alarm only operates when

the ignition is off.

50

Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing

Keys and Remote Controls

REMOTECONTROL-VEHICLES

WITH: KEYLESS ENTRY WITH

REMOTE START

Intelligent Access Key (If Equipped)

E138618

Note: Your vehicle keys came with a

security label that provides important key

cut information. Keep the label in a safe

place for future reference.

E138616

Programming a New Remote

The intelligent access key operates the

power locks and the remote start system.

The key must be in your vehicle to switch

on the push-button start system.

Control

To program an additional remote control

See Security (page 67).

Key Blade

The intelligent access key also contains a

removable key blade that you can use to

unlock your vehicle.

Changing the Remote Control

Battery

The remote control uses one coin-type

three-volt lithium battery CR2032 or

equivalent.

Make sure that you dispose of

old batteries in an

E107998

environmentally friendly way.

Seek advice from your local authority

about recycling old batteries.

1. Remove the key blade from the

transmitter.

E142431

Slide the release on the back of the

transmitter, then pull the blade out.

E142432

51

Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing

Keys and Remote Controls

2. Twist a thin coin under the tab hidden

Sounding the Panic Alarm(IfEquipped)

behind the key blade head to remove

the battery cover.

Press the button to activate the

alarm. Press the button again or

E138624

switch the ignition on to

deactivate it.

Note: The panic alarm only operates when

the ignition is off.

Remote Start

WARNING

To prevent drawing exhaust fumes

into your vehicle, do not use remote

start if your vehicle is parked indoors

or areas that are not well ventilated.

E138622

3. Remove the old battery.

The remote start button is on the

4. Insert a new battery with the + facing

downward. Press the battery down to

make sure it is fully in the housing.

5. Reinstall the battery housing cover

onto the transmitter and install the key

blade.

Note: Do not wipe off any grease on the

battery terminals or on the back surface of

the circuit board.

Note: Replacing the battery does not delete

the transmitter from your vehicle. The

transmitter should operate normally.

transmitter.

E138625

This feature allows you to start your

vehicle from the outside. The transmitter

has an extended operating range.

Vehicles with automatic climate control

can be configured to operate when your

vehicle is remote started. See Automatic

Climate Control (page 104).

Many states and provinces have

restrictions for the use of remote start.

Check your local and state or provincial

laws for specific requirements regarding

remote start systems.

Locating Your Vehicle

Press the lock button on the key twice

within three seconds. The horn sounds and

the direction indicators flash. We

recommend you use this method to locate

your vehicle, rather than using the panic

alarm.

Note: Do not use remote start if your vehicle

is low on fuel.

The remote start system does not work if

any of the following occur:

•

The ignition is on.

The horn sounds twice and the direction

The alarm system activates.

You turn off the feature.

The hood is open.

indicators do not flash if:

•

Locking was not successful.

Any door or the liftgate is open.

The transmission is not in park (P).

The hood is open on vehicles with an

anti-theft alarm or remote start.

52

Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing

Keys and Remote Controls

•

Your vehicle battery has no charge.

Note: If you remote start your vehicle with

an intelligent access transmitter, you must

press the push button ignition switch on the

instrument panel once while applying the

brake pedal before driving your vehicle.

The powertrain fault indicator was on

the last time you drove your vehicle.

Remote Starting your Vehicle

Note: You must press each button within

three seconds of each other. If you do not

follow this sequence, your vehicle does not

start remotely, the direction indicators do

not flash twice and the horn does not sound.

Extending the Engine Running Time

To extend the engine running time duration

of your vehicle during remote start, repeat

steps 1 and 2 while the engine is running.

If the duration is set to 10 minutes, the

duration extends by another 10 minutes.

For example, if your vehicle had been

running from the first remote start for 5

minutes, your vehicle continues to run now

for a total of 20 minutes. You can extend

the engine running time duration to a

maximum of 30 minutes.

Wait at least five seconds before remote

E138626

starting after a vehicle shutdown.

The label on your transmitter details the

starting procedure.

Turning Your Vehicle Off After Remote

Starting

To remote start your vehicle:

Press the button once. The

parking lamps turn off.

1. Press the lock button to lock all the

E138625

doors.

You may have to be closer to

your vehicle than when starting due to

ground reflection and the added noise of

the running vehicle.

2. Press the remote start button twice.

The direction indicators flash twice.

The horn sounds if the system fails to start,

unless quiet start is on. Quiet start runs the

blower fan at a slower speed to reduce

noise. You can switch it on or off using the

information display. See General

Information (page 91).

The power windows do not work during

remote start and the radio does not turn

on automatically.

You can turn the remote start system on

or off using the information display. See

General Information (page 91).

REPLACING A LOST KEY OR

REMOTE CONTROL

You can purchase replacement keys or

remote controls from an authorized dealer.

Authorized dealers can program remote

controls for your vehicle. See Passive

Anti-Theft System (page 67).

The parking lamps remain on and your

vehicle runs for 5, 10 or 15 minutes,

depending on the setting.

To re-program the passive anti-theft

system see an authorized dealer.

53

Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing

Keys and Remote Controls -> Remote Control for Your Ford Focus 4 Door Third generation(2010-2017)

Related Topics

Keys and Remote Controls