Starting and Stopping the Engine -> Engine Block Heater for Your Ford Focus 4 Door Third generation(2010-2017)

Starting and Stopping the Engine  
The heater acts as a starting aid by  
Guarding Against Exhaust Fumes  
WARNING  
If you smell exhaust fumes inside  
your vehicle, have your vehicle  
checked by your authorized dealer  
immediately. Do not drive your vehicle if  
you smell exhaust fumes. Carbon  
monoxide is present in exhaust fumes.  
Take precautions to avoid its dangerous  
effects.  
warming the engine coolant. This allows  
the climate control system to respond  
quickly. The equipment includes a heater  
element (installed in the engine block) and  
a wire harness. You can connect the  
system to a grounded 120-volt AC  
electrical source.  
We recommend that you do the following  
for a safe and correct operation:  
Use a 16-gauge outdoor extension cord  
that is product certified by  
Important Ventilating Information  
Underwriters Laboratory (UL) or  
Canadian Standards Association  
(CSA). This extension cord must be  
suitable for use outdoors, in cold  
temperatures, and be clearly marked  
Suitable for Use with Outdoor  
Appliances. Do not use an indoor  
extension cord outdoors. This could  
result in an electric shock or become a  
fire hazard.  
If you stop your vehicle and then leave the  
engine idling for long periods, we  
recommend that you do one of the  
following:  
Open the windows at least 1.0 in  
(2.5 cm).  
Set your climate control to outside air.  
Use as short an extension cord as  
ENGINE BLOCK HEATER(If  
possible.  
Equipped)  
Do not use multiple extension cords.  
Make sure that when in operation, the  
extension cord plug and heater cord  
plug connections are free and clear of  
water. This could cause an electric  
shock or fire.  
WARNINGS  
Failure to follow engine block heater  
instructions could result in property  
damage or serious personal injury.  
Make sure your vehicle is parked in a  
Do not use your heater with  
ungrounded electrical systems or  
two-pronged adapters. There is a risk  
of electrical shock.  
Do not fully close the hood, or allow  
it to drop under its own weight when  
using the engine block heater. This  
could damage the power cable and may  
cause an electrical short resulting in fire,  
injury and property damage.  
clean area, clear of combustibles.  
Make sure the heater, heater cord and  
extension cord are firmly connected.  
Check for heat anywhere in the  
electrical hookup once the system has  
been operating for approximately 30  
minutes.  
Note: The heater is most effective when  
outdoor temperatures are below 0°F  
(-18°C).  
124  
Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing  
Starting and Stopping the Engine  
Make sure the system is unplugged and  
properly stowed before starting and  
driving your vehicle. Make sure the  
protective cover seals the prongs of the  
block heater cord plug when not in use.  
Make sure the heater system is  
checked for proper operation before  
winter.  
Using the Engine Block Heater  
Make sure the receptacle terminals are  
clean and dry prior to use. Clean them with  
a dry cloth if necessary.  
The heater uses 0.4 to 1.0 kilowatt-hours  
of energy per hour of use. The system does  
not have a thermostat. It achieves  
maximum temperature after  
approximately three hours of operation.  
Using the heater longer than three hours  
does not improve system performance and  
unnecessarily uses electricity.  
125  
Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, First Printing