Seats -> Head Restraints for Your Ford Fusion 4 Door Second Generation (2013-2020)

Seats  
Adjust the head restraint so that the  
top of it is level with the top of your  
head and as far forward as possible.  
Make sure that you remain  
SITTING IN THE CORRECT  
POSITION  
WARNINGS  
comfortable.  
Do not recline the seatback too far  
as this can cause the occupant to  
slide under the seatbelt, resulting in  
serious injury in the event of a collision.  
Keep sufficient distance between  
yourself and the steering wheel. We  
recommend a minimum of 10 in  
(25 cm) between your breastbone and  
the airbag cover.  
Always sit upright against your  
seatback with your feet on the floor.  
Hold the steering wheel with your arms  
slightly bent.  
Do not place objects higher than the  
top of the seat backrest. Failure to  
follow this instruction could result in  
personal injury or death in the event of a  
sudden stop or crash.  
Bend your legs slightly so that you can  
press the pedals fully.  
Position the shoulder strap of the  
safety belt over the center of your  
shoulder and position the lap strap  
tightly across your hips.  
Make sure that your driving position is  
comfortable and that you can maintain full  
control of your vehicle.  
HEAD RESTRAINTS  
WARNINGS  
To minimize the risk of neck injury in  
the event of a crash, the driver and  
passenger occupants should not sit  
in or operate the vehicle, until the head  
restraint is placed in its proper position.  
The driver should never adjust the head  
restraint while the vehicle is in motion.  
E68595  
When you use them properly, the seat,  
head restraint, safety belt and airbags will  
provide optimum protection in the event  
of a crash.  
The adjustable head restraint is a  
safety device. Whenever possible, it  
should be installed and properly  
adjusted when the seat is occupied. Failure  
to adjust the head restraint properly could  
reduce its effectiveness during certain  
impacts.  
We recommend that you follow these  
guidelines:  
Sit in an upright position with the base  
of your spine as far back as possible.  
Install the head restraint properly to  
help minimize the risk of neck injury  
in the event of a crash.  
Do not recline the seat backrest more  
than 30°.  
111  
2017 Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, Second Printing  
Seats  
Note: Adjust the seatback to an upright  
C
D
Guide sleeve adjust and release  
button.  
driving position before adjusting the head  
restraint. Adjust the head restraint so that  
the top of it is level with the top of your head  
and as far forward as possible. Make sure  
that you remain comfortable. If you are  
extremely tall, adjust the head restraint to  
its highest position.  
Guide sleeve unlock and remove  
button.  
Adjusting the Head Restraint  
Raising the Head Restraint  
Frontseatandrearseatoutboardhead  
restraints  
Pull the head restraint up.  
Lowering the Head Restraint  
1. Press and hold button C.  
2. Push the head restraint down.  
Removing the Head Restraint  
1. Pull the head restraint up until it  
reaches its highest position.  
2. Press and hold buttons C and D.  
3. Pull the head restraint up.  
E138642  
Note: For the front head restraints, you may  
need to use a key or similar object to release  
the head restraint. Press the key into the  
guide sleeve unlock and remove button to  
release the head restraint.  
Rear center head restraint  
Installing the Head Restraint  
Align the steel stems into the guide sleeves  
and push the head restraint down until it  
locks.  
Tilting Head Restraints (If Equipped)  
The front head restraints tilt for extra  
comfort. To tilt the head restraint, do the  
following:  
E198013  
The head restraints consist of:  
A
B
An energy absorbing head  
restraint.  
Two steel stems.  
112  
2017 Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, Second Printing