Starting and Stopping the Engine -> Keyless Starting for Your Ford Fusion 4 Door Second Generation (2013-2020)

Starting and Stopping the Engine  
GENERAL INFORMATION  
IGNITION SWITCH  
WARNINGS  
Extended idling at high engine  
speeds can produce very high  
temperatures in the engine and  
exhaust system, creating the risk of fire or  
other damage.  
Do not park, idle or drive your vehicle  
on dry grass or other dry ground  
cover. The emission system heats up  
the engine compartment and exhaust  
system, creating the risk of fire.  
E72128  
0 (off) - The ignition is off.  
Note: When you switch the ignition off and  
leave your vehicle, do not leave your key in  
the ignition. This could cause your vehicle  
battery to lose charge.  
Do not start the engine in a closed  
garage or in other enclosed areas.  
Exhaust fumes can be toxic. Always  
open the garage door before you start the  
engine.  
I (accessory) - Allows the electrical  
accessories, such as the radio, to operate  
while the engine is not running.  
Exhaust leaks may result in entry of  
harmful and potentially lethal fumes  
into the passenger compartment. If  
you smell exhaust fumes inside your  
vehicle, have your vehicle inspected  
immediately. Do not drive if you smell  
exhaust fumes.  
Note: Do not leave the ignition key in this  
position for too long. This could cause your  
vehicle battery to lose charge.  
II (on) - All electrical circuits are  
operational and the warning lamps and  
indicators illuminate.  
If you disconnect the battery, your vehicle  
may exhibit some unusual driving  
III (start) - cranks the engine.  
characteristics for approximately 5 mi  
(8 km) after you reconnect it. This is  
because the engine management system  
must realign itself with the engine. You  
can disregard any unusual driving  
KEYLESS STARTING(If Equipped)  
Note: The system may not function if the  
passive key is close to metal objects or  
electronic devices, for example keys or a cell  
phone.  
characteristics during this period.  
The powertrain control system meets all  
Canadian interference-causing equipment  
standard requirements regulating the  
impulse electrical field or radio noise.  
Note: The ignition automatically turns off  
if you leave your vehicle unattended. This is  
to prevent the vehicle battery from losing  
charge.  
When you start the engine, avoid pressing  
the accelerator pedal before and during  
operation. Only use the accelerator pedal  
when you have difficulty starting the  
engine.  
Note: A valid passive key must be located  
inside your vehicle to switch the ignition on  
and start the engine.  
119  
2017 Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, Second Printing  
Starting and Stopping the Engine  
Note: Releasing the brake pedal during  
engine starting stops the engine cranking.  
Switching the Ignition On to  
Accessory Mode  
Failure to Start  
The system does not function if:  
The passive key frequencies are  
jammed.  
The passive key battery has no charge.  
If you are unable to start your vehicle, do  
the following:  
1
2
E142555  
Press the push button ignition switch once  
without your foot on the brake or clutch  
pedal. It is on the instrument panel near  
the steering wheel. All electrical circuits  
and accessories are operational and the  
warning lamps and indicators illuminate.  
Press the push button ignition switch again  
without your foot on the brake or clutch  
pedal to switch the ignition off.  
E184385  
Starting Your Vehicle  
1. Open the floor console storage  
compartment lid.  
Vehicles with Manual Transmission  
2. Remove the tray.  
1. Fully depress the clutch pedal.  
2. Press the push button ignition switch  
until the engine starts.  
Note: Releasing the clutch pedal during  
engine starting stops the engine from  
cranking.  
VehicleswithAutomaticTransmission  
1. Move the gearshift lever to park (P).  
2. Fully depress the brake pedal.  
3. Briefly press the push button ignition  
switch.  
120  
2017 Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, Second Printing  
Starting and Stopping the Engine  
VehicleswithAutomaticTransmission  
1. Move the gearshift lever to park (P).  
2. Press the push button ignition switch.  
3
Note: The ignition, all electrical circuits and  
all warning lamps and indicators will be  
turned off.  
Stopping the Engine When Your  
Vehicle is Moving  
WARNING  
Switching off the engine when the  
vehicle is still moving will result in a  
loss of brake and steering assistance.  
The steering will not lock, but higher effort  
will be required. When the ignition is  
switched off, some electrical circuits,  
including air bags, warning lamps and  
indicators may also be off. If the ignition  
was turned off accidentally, you can shift  
into neutral (N) and re-start the engine.  
E184386  
3. Place the passive key flat on the  
symbol at the bottom of the floor  
console storage compartment.  
4. With the passive key in this position,  
you can use the push button ignition  
switch to switch the ignition on and  
start your vehicle.  
1. Press and hold the push button ignition  
switch until the engine stops, or press  
it three times within two seconds.  
Vehicles with Manual Transmission  
If the engine does not crank when the  
clutch pedal has been fully depressed and  
the push button ignition switch is pressed,  
do the following:  
2. Move the gearshift lever to neutral and  
use the brakes to bring your vehicle to  
a safe stop.  
3. With your vehicle stopped, move the  
gearshift lever to park (P) and switch  
the ignition off.  
1. Fully depress both the clutch and brake  
pedals.  
2. Press the push button ignition switch  
until the engine starts.  
Fast Restart  
Note: Releasing the clutch pedal during  
engine starting stops the engine cranking.  
A message appears in the information  
display.  
The fast restart feature allows you to  
restart your vehicle within 10 seconds of  
switching it off, even if a valid passive key  
is not detected.  
Stopping the Engine When Your  
Vehicle is Stationary  
Within 10 seconds of switching your vehicle  
off, press the brake pedal and press the  
push button ignition switch. After 10  
seconds, you can no longer start your  
vehicle if it does not detect a valid passive  
key.  
Vehicles with Manual Transmission  
Briefly press the push button ignition  
switch.  
121  
2017 Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, Second Printing