Wipers and Washers
Note: Move to position O marked on the
wiper lever to switch off.
WINDSHIELD WIPERS
Note: Fully defrost the windshield before
you switch the windshield wipers on.
Intermittent Wipe
Note: Make sure you switch the windshield
wipers and vehicle power off before using
an automatic car wash.
Note: If streaks or smears appear on the
windshield, clean the windshield and the
wiper blades. See Checking the Wiper
Blades (page 225). If that does not resolve
the issue, install new wiper blades. See
Changing the Front Wiper Blades (page
225).
Note: Do not operate the wipers on a dry
windshield. This may scratch the glass,
damage the wiper blades or cause the wiper
motor to burn out. Always use the
windshield washers before wiping a dry
windshield.
E197526
A
B
C
Short-wipe interval.
Intermittent wipe.
Long-wipe interval.
Note: When wiping on dry glass, the wipers
may switch to the next lower operating
mode (low-speed or intermittent). The
previous operation mode may resume after
the windshield becomes wet again.
Push the wiper lever up to switch the
wipers on, and then use the rotary control
to adjust the intermittent wipe interval.
Speed Dependent Wipers(If Equipped)
When your vehicle speed increases, the
interval between wipes decreases.
WINDSHIELD WASHERS
Note: Do not operate the washers when
the washer reservoir is empty. This may
cause the washer pump to overheat.
E197525
A
B
C
D
Single wipe.
Intermittent wipe.
Normal wipe.
High-speed wipe.
74
2017 Focus (CDH) Canada/United States of America, HM5J 19A321 AA enUSA, Edition date: 201608, Second Printing
English 