Maintenance
The coolant should be added when
Brake and clutch fluid systems are
supplied from the same reservoir.
the engine is cold. If coolant has to
be added when the engine is hot, first
wait 10 minutes for the engine to
cool. Unscrew the cap slowly. Any
pressure will escape while you are
turning the cap. Fully remove the cap.
The level of the fluid must be
between the MIN and MAX marks
on the side of the reservoir.
POWER STEERING FLUID
CHECK
WARNING
Do not allow this fluid to make
contact with the skin or eyes. If
this should happen rinse the affected
areas immediately with plenty of
water and contact your doctor.
Add coolant that meets the Ford
Specification.
BRAKE AND CLUTCH
FLUID CHECK
E69130
Switch off the engine. With the
steering system at normal operating
temperature, the fluid level should
come up to the MAX mark.
If it drops below the MIN mark, top
up with the specified fluid.
WASHER FLUID CHECK
E69126
WARNING
Do not allow this fluid to make
contact with the skin or eyes. If
this should happen rinse the affected
areas immediately with plenty of
water and contact your doctor.
E69168
88
English 
