Driving Aids -> Speed Limiter for Your Ford Kuga SUV Second Generation (2013-2018)

Driving Aids  
SPEED LIMITER  
Principle of Operation  
C
D
Set speed decrease  
Cancel and resume  
WARNING  
Switching the System On and Off  
When you are going downhill, your  
speed may increase above the set  
speed. The system will not apply the  
brakes but a warning will be given.  
Press switch B. The information display  
will prompt you to set a speed.  
Setting the Speed Limit  
Use the cruise control switches to alter the  
The system allows you to set a speed, to  
which your vehicle then becomes limited.  
The set speed will become the effective  
maximum speed of your vehicle, but with  
the option to temporarily exceed this limit  
if required.  
maximum speed setting.  
Press switch A or C to select your desired  
speed limit. The speed is displayed in the  
information display and stored as the set  
speed.  
Pull switch D to cancel the limiter and  
place it in standby mode. The information  
display will confirm this has been turned  
off by showing the set speed crossed out.  
Pull switch D again to resume the limiter.  
The information display will confirm this  
has been turned on by showing the set  
speed again.  
Using the System  
Note: The set speed limit can be  
intentionally exceeded for a short period of  
time if required, for example when  
overtaking.  
The system is operated by adjustment  
controls mounted on the steering  
wheel.  
Intentionally Exceeding the Set Speed  
Limit  
Depress the accelerator fully to temporarily  
turn the system off. The system will turn  
on once your vehicle speed drops below  
the set speed.  
System Warnings  
If you accidently exceed the set speed, it  
will flash in the information display and  
you will hear and audible warning chime.  
If you intentionally exceed the set speed,  
it will flash in the information display.  
A
B
Set speed increase  
On and off  
151  
Kuga (CBS) Vehicles Built From: 08-09-2014 Vehicles Built Up To: 31-05-2015, CG3585en enGBR, Edition date: 08/2014, Second Printing  
Driving Aids  
Note: Keep the windshield free from  
DRIVER ALERT(If Equipped)  
obstructions such as bird droppings, insects  
and snow or ice.  
Principle of Operation  
WARNINGS  
Note: The system assists you when driving  
on fast main roads and freeways.  
The system does not relieve you of  
your responsibility to drive with due  
care and attention.  
Note: The system calculates an alertness  
level at vehicle speeds above approximately  
40 mph (65 km/h).  
At all times you are responsible for  
controlling your vehicle, supervising  
the system and intervening if  
required.  
The system automatically monitors your  
driving behavior.  
The system is designed to alert you if it  
detects that you are becoming drowsy or  
if your driving deteriorates.  
If the sensor becomes blocked the  
system may not function.  
Using Driver Alert  
Switching the System On and Off  
Take regular rest breaks as required  
and do not wait for the system to  
warn you if you feel tired.  
Note: The system will remain on or off  
Take rest breaks only where it is safe  
depending on how it was last set.  
to do so.  
Switch the system on using the information  
display. See InformationDisplays (page  
69).  
The system will calculate your alertness  
level based upon your driving behavior in  
relation to the lane markings and other  
factors.  
Certain driving styles and behavior  
may result in the system issuing a  
warning even if you are not feeling  
tired.  
In cold and severe weather  
conditions the system may not  
function. Rain, snow, spray and large  
contrasts in lighting can all influence the  
sensor.  
System Warnings  
Note: The system will not issue warnings  
The system will not operate if the  
sensor cannot track the road lane  
markings.  
below approximately 40 mph (65 km/h).  
The warning system has two stages:  
1. A temporary warning is issued to advise  
you to take a rest. This message only  
appears for a short time.  
2. If you do not rest and the system  
continues to detect that your driving  
deteriorates, it will issue a further  
warning. This will remain in the  
information display until you cancel it.  
See Information Messages (page  
75).  
The system may not operate in areas  
during roadwork construction.  
The system may not operate on  
roads with sharp bends or narrow  
lanes.  
Do not carry out windshield repairs  
in the immediate area surrounding  
the sensor.  
If your vehicle has a suspension kit  
not approved by us, the system may  
not function correctly.  
Press OK on the steering wheel control to  
remove the warning.  
152  
Kuga (CBS) Vehicles Built From: 08-09-2014 Vehicles Built Up To: 31-05-2015, CG3585en enGBR, Edition date: 08/2014, Second Printing