2015-2023 Ford Mustang 2 Door Child Safety User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Child Safety for Your Ford Mustang 2 Door Sixth Generation (2015-2023)

CHILD RESTRAINTS
WARNINGS
Children must always be properly
restrained.
This section provides useful
information on the installation and
safe use of child restraints. Ford
strongly recommends that you read and
understand this section before carrying
children in your vehicle.
It is the driver’s responsibility to ensure that
the children are seated in suitable child
restraints prescribed by the laws of the
State or Territory in which the vehicle is
operated.
If you are in any doubt about the laws that
apply in your location, please consult your
local Authorised Ford Dealer or Local
Approved Child Restraint Fitting Station
for assistance.
WARNING
NEVER use a rearward facing child
restraint on a seat protected by an
ACTIVE AIRBAG in front of it, DEATH
or SERIOUS INJURY to the CHILD can
occur.
E212161
WARNINGS
Seatbelts and seats can become hot
in a vehicle that has been closed up
in sunny weather, they could burn a
small child. Check seat covers and buckles
before you place a child anywhere near
them.
Read and follow the child restraint
manufacturer’s instructions when
you are fitting a child restraint.
Do not alter or modify child restraints
in any way.
Do not hold a child on your lap when
the vehicle is moving.
Do not leave children unattended in
your vehicle.
On hot days, the temperature inside
the vehicle can rise very quickly.
Exposure of people or animals to
these high temperatures for even a short
time can cause death or serious heat
related injuries, including brain damage.
Small children are particularly at risk.
Destroy the child restraint if it has
been in a severe crash, even if no
damage is visible.
12
Mustang (CZG) Australia, Vehicles Built From: 07-08-2017, JR3J 19A321 ZAB enAUS, Edition date: 201709, Second Printing
Child Safety
SELECTING A CHILD
RESTRAINT SYSTEM
To provide protection, a child restraint
system should meet three requirements.
1. The child restraint system complies
with Australian Standard AS1754.
Infants and children must be properly
restrained at all times in an approved
child restraint which conforms to
Australian Standards AS1754 - 2004
or later. Look for the Australian
Standard Approval Mark on the child
restraint.
2. The child restraint must be suitable
for the size and weight of the child
and must be properly fitted and
adjusted. Use the child restraint
exactly as shown in the instructions
provided with the child restraint. If you
have any doubts, contact the child
restraint manufacturer or consult an
approved Restraint Fitting Station.
3. The child restraint system should
fit the vehicle seating position (or
positions) where it will be used. Due
to variations in the design of child
restraint systems, vehicle seats and
seatbelts, all child restraint systems
may not fit all seating positions. Before
purchasing a child restraint system, it
is recommended that the child restraint
system is tested in the specific vehicle
seating position (or positions) where
it is intended to be used. If a previously
purchased child restraint does not fit,
you may need to purchase a different
one that will fit.
INSTALLING CHILD
RESTRAINTS
WARNINGS
NEVER use a rearward facing child
restraint on a seat protected by an
ACTIVE AIRBAG in front of it, DEATH
or SERIOUS INJURY to the CHILD can
occur.
Incorrectly fitted child restraints may
swing, tip or come away causing
death or injury.
Do not use a child restraint if the
tether strap falls into a split in the
vehicle seat back or falls off the edge
of the vehicle seat.
After installing a child restraint system,
push and pull the system forward and back
and from side to side to verify that it is
secured.
Be sure to read and follow the instructions
provided by the child restraint
manufacturer. If you have any doubts
contact the child restraint manufacturer
or consult an approved Restraint Fitting
Station. Your automobile club or local
vehicle registration authority can provide
location details of fitting stations.
When installing the child restraint
attaching clip to the anchor fitting, raise
the head restraint (where fitted) and pass
the tether strap between the head restraint
supports. This will prevent the tether strap
from falling off the outboard edge of the
seating positions.
13
Mustang (CZG) Australia, Vehicles Built From: 07-08-2017, JR3J 19A321 ZAB enAUS, Edition date: 201709, Second Printing
Child Safety
E166723
Note: Side curtain air bags (where fitted)
will not interfere with a properly installed
child restraint system or booster seat,
because they are designed to inflate
downward from the headliner above the
doors along the side window openings.
When a child restraint system is not being
used, either remove it and store it in a safe
place, or make sure it is properly secured.
An unsecured child restraint system can
be thrown around the vehicle in a collision
or sudden stop and injure someone.
CHILD RESTRAINT
ANCHORAGE LOCATIONS
Upper (top tether) anchorages
WARNING
Child restraint anchorages are
designed to withstand only those
loads imposed by correctly fitted
child restraints. Under no circumstances
are they to be used for adult seatbelts,
harnesses or for attaching other items or
equipment to the vehicle.
There are two child restraint top tether
anchorages, one for each rear seating
position.
The top tether anchorages are only
suitable for child restraints conforming to
Australian Standard AS1754-2004 or later.
Coupe
E217152
E217153
Note: Arrow points to front of vehicle.
If your child restraint does not have an
approved latched hook attaching clip as
shown, you should consult an approved
restraint fitting station.
14
Mustang (CZG) Australia, Vehicles Built From: 07-08-2017, JR3J 19A321 ZAB enAUS, Edition date: 201709, Second Printing
Child Safety
Convertible
E217154
E217155
Note: Arrow points to front of vehicle.
Note: For easier access, attach the tether
with the convertible top up.
WARNINGS
Always ensure that the attaching clip
is properly engaged with the anchor
fitting and the tether strap length is
adjusted to remove any slack.
Always ensure that the locking
mechanism of the rear seatback is
fully engaged when in the upright
position, by attempting to pull it down
again.
Do not attach a tether strap to
anything other than the correct
tether anchor point.
Make sure that the seatback is
secure and fully engaged in the
catch.
Make sure that the tether strap
tightening mechanism remains
accessible when the seatback is fully
engaged in the catch.
ISOFIX LOWER ANCHORAGES
WARNING
The ISOFIX lower anchorages must
be used in conjunction with the upper
(top tether) anchorages.
Your vehicle has ISOFIX lower anchorages
located in the lower backrest of the rear
seats, as shown in the following picture.
E187773
15
Mustang (CZG) Australia, Vehicles Built From: 07-08-2017, JR3J 19A321 ZAB enAUS, Edition date: 201709, Second Printing
Child Safety
PROTECTING LARGER
CHILDREN
The rear seats (where provided) are the
safest place for children.
When a child outgrows the recommended
weight or height limits for a forward facing
child restraint system, the child should sit
on a booster seat and wear a lap-sash
seatbelt. The raised seating position will
allow you to position the shoulder strap of
the adult seatbelt over the centre of your
child's shoulder and the lap strap tightly
across its hips. A booster seat should be
used until the child is tall enough for the
lap-sash seatbelt to fit properly.
Typical Booster Seat
E70710
WARNINGS
Do not install a booster seat with
only the lap strap of the seatbelt.
Do not install a booster seat with a
seatbelt that is slack or twisted.
CHECKING SEATBELT FIT
If the lap-sash seatbelt touches or crosses
the child's neck, then the child needs a
booster seat.
WARNINGS
Never wear a seatbelt across the
neck. This could result in serious neck
injury in the event of a collision.
Do not put the seatbelt under your
child's arm or behind its back.
Do not use pillows, books or towels
to boost your child's height.
Make sure that your children sit in an
upright position.
16
Mustang (CZG) Australia, Vehicles Built From: 07-08-2017, JR3J 19A321 ZAB enAUS, Edition date: 201709, Second Printing
Child Safety

Related Topics

Popular Owner Manuals