2015-2023 Ford Mustang 2 Door Keys and Remote Controls -> Remote Control User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Keys and Remote Controls -> Remote Control for Your Ford Mustang 2 Door Sixth Generation (2015-2023)

GENERAL INFORMATION ON
RADIO FREQUENCIES
Note: Changes or modifications not
expressly approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
The typical operating range for your
transmitter is approximately 10 m.
A decrease in operating range could be
caused by:
• weather conditions
• nearby radio towers
• structures around your vehicle
• other vehicles parked next to your
vehicle.
The radio frequency used by your remote
control can also be used by other radio
transmitters, for example amateur radios,
medical equipment, wireless headphones,
wireless remote controls, cell phones,
battery chargers and alarm systems. If the
frequencies are jammed, you will not be
able to use your remote control. You can
lock and unlock the doors with the key.
Note: Make sure your vehicle is locked
before leaving it unattended.
Note: If you are in range, the remote control
will operate if you press any button
unintentionally.
Note: The remote control contains sensitive
electrical components. Exposure to moisture
or impact may cause permanent damage.
REMOTE CONTROL
Passive Key
Note: You may not be able to shift out of
park (P) unless the passive key is inside your
vehicle.
E258628
The passive key operates the power locks
and remote start system. The key must be
in your vehicle to use the push button start.
Removable Key Blade
The passive key also contains a removable
key blade that you can use to unlock your
vehicle.
29
Mustang (CZG) Australia, Vehicles Built From: 07-08-2017, JR3J 19A321 ZAB enAUS, Edition date: 201709, Second Printing
Keys and Remote Controls
E258629
Push the release button and pull the key
blade out.
E151795
Note: Your vehicle keys came with a
security label that provides important key
cut information. Keep the label in a safe
place for future reference.
Using the Key Blade
The key cylinder is under a cap on the driver
door handle.
To remove the cap:
E151956
1. Insert the key blade into the slot on the
bottom of the handle and apply
upward pressure.
2. While maintaining upward pressure,
move the cap rearward to release it.
Gently remove the key while doing so.
To install the cap:
E151957
1. Place the cap just forward of the key
cylinder.
2. Applying pressure to the cap, move it
forward until it is in place. You may
hear a snap as it engages.
30
Mustang (CZG) Australia, Vehicles Built From: 07-08-2017, JR3J 19A321 ZAB enAUS, Edition date: 201709, Second Printing
Keys and Remote Controls
Make sure you have properly installed the
cap by trying to move it rearward.
Replacing the Battery
Note: Refer to local regulations when
disposing of transmitter batteries.
Note: Do not wipe off any grease on the
battery terminals or on the back surface of
the circuit board.
Note: Replacing the battery does not erase
the programmed key from your vehicle. The
transmitter should operate normally.
A message appears in the information
display when the remote control battery
is low. See Information Messages (page
69).
The remote control uses one coin-type
three-volt lithium battery.
E258629
1. Push the release button and pull the
key blade out.
E252404
2. Twist a thin coin under the tab hidden
behind the key blade head to remove
the battery cover.
31
Mustang (CZG) Australia, Vehicles Built From: 07-08-2017, JR3J 19A321 ZAB enAUS, Edition date: 201709, Second Printing
Keys and Remote Controls

Related Topics

Popular Owner Manuals