What to do in an emergency
IN CASE OF AN EMERGENCY
WHILE DRIVING
ROAD WARNING
It should be used whenever emergency
repairs are being made or when the vehi-
cle is stopped near the edge of a road-
way.
F020100AUN
If the engine stalls at a crossroad
or crossing
Depress the flasher switch with the igni-
tion switch in any position. The flasher
switch is located in the center console
switch panel. All turn signal lights will
flash simultaneously.
• If the engine stalls at a crossroad or
crossing, set the shift lever in the N
(Neutral) position and then push the
vehicle to a safe place.
• If your vehicle has a manual transaxle
not equipped with a ignition lock
switch, the vehicle can move forward
by shifting to the 2 (second) or 3 (third)
gear and then turning the starter with-
out depressing the clutch pedal.
• The hazard warning flasher operates
whether your vehicle is running or not.
OSA047061
• The turn signals do not work when the
hazard flasher is on.
F010100ASA
Hazard warning flasher
• The hazard warning flasher should
always be on while the vehicle is being
towed.
The hazard warning flasher serves as a
warning to other drivers to exercise
extreme caution when approaching,
overtaking, or passing your vehicle.
F020100ASA
If you have a flat tire while driving
If a tire goes flat while you are driving:
1.Take your foot off the accelerator pedal
and let the car slow down while driving
straight ahead. Do not apply the brakes
immediately or attempt to pull off the
road as this may cause a loss of con-
trol. When the car has slowed to such
a speed that it is safe to do so, brake
carefully and pull off the road. Drive off
the road as far as possible and park on
a firm level ground. If you are on a
divided highway, do not park in the
median area between the two traffic
lanes.
6 2
English 
