2005-2010 Mercedes B Class SUV Technical data -> Vehicle electronics User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Technical data -> Vehicle electronics for Your Mercedes B Class SUV First Generation (2005-2010)

This is the case if:
R
they cause a change of the vehicle type
from that for which the vehicle's general
operating permit was granted.
R
other road users could be endangered.
R
the emission or noise levels are adversely
affected.
Always specify the vehicle identification num-
ber (VIN) (Y page 310) and the engine num-
ber (Y page 311) when ordering genuine
Mercedes-Benz parts.
Vehicle electronics
Tampering with the engine electron-
ics
G
WARNING
Always have work on the engine electronics
and related components carried out at a quali-
fied specialist workshop. Otherwise, the vehi-
cle's operating safety could be affected.
!
Only have work carried out on the engine
electronics and its associated parts, such
as control units, sensors and connector
leads, at a qualified specialist workshop.
Vehicle components may otherwise wear
more quickly and the vehicle's operating
permit may be invalidated.
Retrofitting of two-way radios and
mobile phones (RF transmitters)
G
WARNING
Incorrect retrofitting of RF transmitters can
cause the vehicle electronics to malfunction.
The vehicle's operating safety and thus your
own safety are impaired.
Have aftermarket radio frequency transmit-
ting equipment installed at a qualified spe-
cialist workshop.
G
WARNING
Incorrect retrofitting of RF transmitters can
lead to increased electromagnetic radiation in
the vehicle interior. Using an exterior aerial
takes into account current scientific discus-
sions relating to the possible health hazards
that may result from electromagnetic fields.
Have aftermarket radio frequency transmit-
ting equipment installed at a qualified spe-
cialist workshop.
!
The operating permit may be invalidated
if the instructions for installation and use of
RF transmitters are not observed.
In particular, the following conditions must
be complied with:
R
only approved wavebands may be used.
R
the maximum permissible output in
these wavebands must be complied with.
R
the approved aerial positions must be
complied with.
The following aerial positions may be used if
RF transmitters have been properly installed:
:
Front roof area
18
;
Rear roof area
=
Rear wing
19
18
Vehicles with a panorama sliding sunroof: this area is not permitted.
19
Recommended installation position: on the side which faces the centre of the road.
Vehicle electronics
309
Technical data
Z
Use the Technical Specification
ISO/TS 21609
20
when retrofitting RF (radio
frequency) transmitters. Legal provisions for
fittings must be observed.
If your vehicle has fittings for two-way radio
equipment, use the power supply or aerial
connections intended for use with the basic
wiring. Be sure to observe the manufacturer's
additional instructions when installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or aerial positions
must be approved by Mercedes-Benz.
The maximum transmission output (PEAK) at
the base of the aerial must not exceed the
following values:
Waveband Maximum
transmission
output
Short wave (f < 54 MHz) 100 W
4 m waveband 30 W
2 m waveband 50 W
Trunked radio/Tetra 35 W
70 cm waveband 35 W
GSM/DCS/PCS
850/900/1800/1900
10 W
UMTS/LTE 10 W
The following can be used in the vehicle with-
out restrictions:
R
RF transmitters with amaximum transmis-
sion output of up to 100 mW
R
mobile phones (GSM/DCS/PCS/UMTS/
LTE)
There is no restriction for aerial positions in
the outer area of the vehicle for the following
wavebands:
R
trunked radio/Tetra
R
70 cm waveband
R
GSM/DCS/PCS
R
UMTS/LTE
Vehicle identification plates
Vehicle identification plate with vehi-
cle identification number (VIN) and
paint code number
X
Open the frontright-hand door.
You will see vehicle identification plate :.
Example: vehicle identification plate
:
Vehicle identification plate
;
Vehicle manufacturer (Daimler AG)
=
EU general operating permit number (only
for certain countries)
?
Vehicle identification number (VIN)
A
Maximum permissible gross weight (kg)
B
Maximum permissible gross weight of
vehicle/trailer combination (kg)
C
Maximum permissible front axle load (kg)
20
ISO/TS 21609 – Technical Specification for Road Vehicles – EMC guidelines for installation of aftermarket
radio frequency transmitting equipment.
310
Vehicle identification plates
Technical data

Related Topics

Popular Owner Manuals