X
Tighten the wheel bolts until they are fin-
ger-tight.
Lowering the vehicle
X
Place the ratchet ring spanner onto the
hexagon nut of the jack so that the letters
AB are visible.
X
Turn the ratchet ring spanner until the vehi-
cle is once again standing firmly on the
ground.
X
Place the jack to one side.
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
X
Tighten the wheel bolts evenly in a cross-
wise pattern in the sequence indicated
(: to A). The tightening torque must be
130 Nm.
X
Turn the jack back to its initial position.
X
Stow the jack and the rest of the vehicle
tools in the vehicle again.
X
Check the tyre pressure of the newly fitted
wheel and adjust it if necessary.
Observe the recommended tyre pressure
(Y page 295).
Wheel and tyre combinations
Points to remember
!
For safety reasons, Mercedes-Benz rec-
ommends that you only use tyres and
wheels which have been approved by
Mercedes-Benz specifically for your vehi-
cle.
These are specially adapted to the control
systems, such as ABS or ESP
®
and are
marked as follows:
R
MO =Mercedes-BenzOriginal
R
MOE =Mercedes-BenzOriginal Extended
(tyres featuring run-flat characteristics)
R
MO1 =Mercedes-BenzOriginal (only cer-
tain AMG tyres)
Mercedes-Benz Original Extended tyres
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tyres, wheels or accessories tes-
ted and approved by Mercedes-Benz. Cer-
tain characteristics, e.g. handling, vehicle
noise emissions or fuel consumption, may
otherwise be adversely affected. In addi-
tion, when driving with aload, tyre dimen-
sion variations could cause the tyres to
come into contact with the bodywork and
axle components.This could result in dam-
age to the tyres or the vehicle.
Mercedes-Benzaccepts no liability for
damage resulting from the use of tyres,
wheels or accessories otherthan those tes-
ted and approved.
Further information about wheels, tyres
and approved combinations can be
obtained from any qualified specialist
workshop.
!
Large wheels: the lower the section width
for a certain wheel size, the lower the ride
comfort is on poor road surfaces. Roll com-
fort and suspension comfort are reduced
and the risk of damage to the wheels and
tyres as a result of driving over obstacles
increases.
302
Wheel and tyre combinations
Wheels and tyres
English 
