Get Safety?Seats, seat belts and supplemental restraint system -> Rear-facing child restraint installation using LATCH Guide for Nissan Micra 4 Door Fourth Generation (2010-2016)

The child restraint top tether strap must be used

when installing the child restraint with the LATCH

lower anchor attachments or seat belts. For ad-

ditional information, refer to “Installing top tether

strap” in this section.

If you have any questions when installing a

top tether strap child restraint, consult your

NISSAN dealer for details.

REAR-FACING CHILD RESTRAINT

INSTALLATION USING LATCH

For additional information, refer to all Warnings

and Cautions in the “Child safety” and “Child

restraints” sections of this manual before install-

ing a child restraint.

Do not use the lower anchors if the combined

weight of the child and the child restraint exceeds

65 lbs (29.5 kg). If the combined weight of the

child and the child restraint is greater than 65 lbs,

(29.5 kg) use the vehicle’s seat belt (not the

lower anchors) to install the child restraint. Be

sure to follow the child restraint manufacturer’s

instructions for installation.

Follow these steps to install a rear-facing child

restraint using the LATCH system:

1. Position the child restraint on the seat. Al-

ways follow the child restraint manufactur-

er’s instructions.

2. Secure the child restraint anchor attach-

ments to the LATCH lower anchors. Check

to make sure the LATCH attachment is prop-

erly attached to the lower anchors.

Rear-facing webbing-mounted – step 2

WRS0801

Rear-facing rigid-mounted – step 2

WRS0802

Safety—Seats, seat belts and supplemental restraint system 1-23

3. For child restraints that are equipped with

webbing-mounted attachments, remove any

additional slack from the anchor attach-

ments. Press downward and rearward firmly

in the center of the child restraint with your

hand to compress the vehicle seat cushion

and seatback while tightening the webbing

of the anchor attachments.

4. After attaching the child restraint, test it be-

fore you place the child in it. Push it from side

to side while holding the child restraint near

the LATCH attachment path. The child re-

straint should not move more than 25 mm

(1 in), from side to side. Try to tug it forward

and check to see if the LATCH attachment

holds the restraint in place. If the restraint is

not secure, tighten the LATCH attachment

as necessary, or put the restraint in another

seat and test it again. You may need to try a

different child restraint or try installing by

using the vehicle seat belt (if applicable).

Not all child restraints fit in all types of ve-

hicles.

5. Check to make sure the child restraint is

properly secured prior to each use. If the

child restraint is loose, repeat steps 1

through 4.

Rear-facing – step 3

LRS0673

Rear-facing – step 4

LRS0674

1-24 Safety—Seats, seat belts and supplemental restraint system

Safety?Seats, seat belts and supplemental restraint system -> Rear-facing child restraint installation using LATCH for Your Nissan Micra 4 Door Fourth Generation (2010-2016)

Related Topics

Popular Owner Manuals

Latest Owner Manuals