FOUR-WHEEL DRIVE (4WD)
MANUAL SHIFTING (4WD models)
This section describes the procedure for manu-
ally shifting the vehicle into the 4WD mode (4L
position) in case of an emergency.
OPERATING PROCEDURE
WARNING:
Place the ignition switch in the “OFF” position
and apply the parking brake. Let the vehicle
cool down before performing the following
procedure.
.
.
.
Ensure your safety before performing the
operations. The vehicle may move unex-
pectedly.
Place the ignition switch in the “OFF”
position, apply the parking brake and let
the vehicle cool down.
Do not perform the following procedure
immediately after driving the vehicle.
Parts such as exhaust components, the
transmission, etc. are very hot and may
cause a burn injury.
Make sure that the parts that will be
operated as well as related parts cool
down before performing the operation.
Burrs or projecting portions of metal
components may cause unexpected in-
jury to your fingers or arms. Pay special
attention in regard to your safety while
removing and installing these parts. Wear
work gloves and protective arm covers.
WHEN 4WD WARNING LIGHT ILLUMI-
NATES
If the 4WD warning light illuminates while
driving, there may be
a malfunction in the
4WD system. Stop the vehicle and have the
vehicle checked by a NISSAN dealer as soon as
possible. (See “Four-Wheel Drive (4WD) (4WD
models)” (P.5-16).)
When the vehicle is stuck on an uneven road
(desert, mud, etc.) and the 4WD warning light is
illuminated, be sure to place the 4WD shift
switch in the 4L position. If only the rear wheels
are spinning, this means that the transfer has
not switched to the 4L position electrically.
If this situation occurs, contact a dealer or road
assistance service for help. If an immediate
service is not available, perform the following
procedure to switch to the 4L position manu-
ally and free the vehicle.
.
.
SCE0959
4WD shift motor assembly
1. Check that the ignition switch is in the
“OFF” position.
CAUTION:
The following procedure includes the re-
moval of the electrical system components.
Therefore, make sure that the ignition switch
is in the “OFF” position before proceeding.
CAUTION:
CAUTION:
While removing and installing the parts,
prevent the removed parts from getting dirty
with water, dirt or sand. Protect the parts
using a cover such as a clean cloth, etc.
Only perform this procedure in an emer-
gency.
If the vehicle is driven for a long period of
time over a long distance with a component
detached, foreign material such as water,
sand, etc. may enter from the opening and
this may cause a malfunction in the drive-
train system. After freeing a vehicle that has
become stuck, be sure to contact a NISSAN
dealer for inspection and repair.
6-14 In case of emergency
English 
