2019-2025 Peugeot 2008 SUV Access -> Back-up procedures User Manual

MY CAR USER MANUAL

Access -> Back-up procedures for Your Peugeot 2008 SUV Second Generation (2019-2025)

Access  
Electrical interference  
The electronic key may not operate if  
close to certain electronic devices such as  
telephones (switched on or on standby) or  
laptop computers, strong magnetic fields, etc.  
► After normal locking, pull one of the  
interior door controls to unlock the vehicle.  
► After deadlocking, you must use the  
remote control, the "Keyless Entry and  
Starting" system or the built-in key to unlock  
the vehicle.  
Back-up procedures  
Lost keys, remote control,  
electronic key  
Go to a PEUGEOT dealer with the vehicle's  
registration certificate, your personal  
identification documents and if possible, the label  
bearing the key code.  
The PEUGEOT dealer will be able to retrieve the  
key code and the transponder code, enabling a  
new key to be ordered.  
Central locking  
Automatic (anti-intrusion  
security)  
The doors and boot lock automatically while  
driving (speed above 6 mph (10 km/h)).  
To deactivate/reactivate this function (activated  
by default):  
Complete unlocking/locking  
of the vehicle with the key  
► Press the button until a confirmation  
message appears.  
Use this procedure in the following situations:  
– Remote control battery discharged.  
– Remote control malfunction.  
– Vehicle battery discharged.  
– Vehicle in an area subject to strong  
electromagnetic interference.  
In the first case, change the remote control  
battery.  
Transporting long or voluminous  
objects  
Manual  
► Press this button to lock/unlock the vehicle  
(doors and boot) from inside the passenger  
compartment.  
The indicator lamp comes on to confirm the  
central locking of the vehicle.  
Press the central locking control to drive  
with the boot open and the doors locked.  
Otherwise, every time the speed of the  
vehicle exceeds 6 mph (10 km/h), the sound  
of the locks rebounding will be heard and an  
alert will be displayed.  
In the second case, reinitialise the remote  
control.  
Refer to the corresponding sections.  
Central locking does not take place if any  
of the doors are open.  
When locking/deadlocking from the  
outside  
When the vehicle is locked or deadlocked  
from the outside, the indicator lamp flashes  
and the button is deactivated.  
32  
Access  
► Insert the key in the door lock.  
► Turn the key towards the front/rear to unlock/  
lock the vehicle.  
► Turn the key towards the rear again within  
3 seconds to deadlock the vehicle.  
Passenger doors  
Changing the battery  
If the battery is flat, this warning lamp  
comes on, accompanied by an audible  
signal and the display of a message.  
2
Unlocking  
► Pull the interior door opening control.  
Locking  
Battery type: CR2032/3 volts.  
If the vehicle is fitted with an alarm, it will  
not be activated when locking with the  
key.  
Without Keyless Entry and Starting  
If the alarm is activated, the siren sounds  
when the door is opened; switch on the  
ignition to stop it.  
Central locking not  
functioning  
Use these procedures in the following cases:  
– Central locking malfunction.  
– Battery disconnected or discharged.  
► Open the doors.  
► For the rear doors, check that the child lock  
is not on.  
Refer to the corresponding section.  
► Remove the black cap, located on the edge  
of the door, using the key.  
With Keyless Entry and Starting  
In the event of a malfunction of the  
central locking system, the battery must  
be disconnected to ensure that the vehicle is  
locked fully.  
► Insert the key into the socket without forcing  
it, then turn the latch towards the inside of the  
door.  
► Remove the key and refit the black cap.  
► Close the doors and check from the outside  
that the vehicle is locked.  
Driver's or front left-hand door  
(depending on version)  
► Insert the key into the door lock.  
► Turn the key towards the rear of the vehicle  
to lock it, or towards the front to unlock it.  
33  
Access  
► Unclip the cover by inserting a small  
screwdriver in the slot and lift the cover.  
► Remove the flat battery from its housing.  
► Put the new battery in place, respecting the  
polarity. Start by inserting it into the contacts  
located in the corner, then clip the cover onto  
the unit.  
► Reinitialise the remote control.  
For more information on Reinitialising the  
remote control, refer to the corresponding  
section.  
Risk of explosion if the battery is  
replaced by an incorrect type.  
Replace battery with the same type.  
► Turn the key to position 2 (Ignition on).  
► Immediately press the closed padlock button  
for a few seconds.  
► Switch off the ignition and remove the key  
from the ignition switch.  
Risk of explosion or the leakage of  
flammable liquid or gas.  
The remote control is now fully operational  
again.  
Do not use in /store in /bring into environment  
of extremely high temperature or extremely  
low pressure due to the very high altitude.  
Do not attempt to burn, crush, or cut used  
battery.  
With Keyless Entry and Starting  
Do not throw remote control batteries  
away, as they contain metals that are  
harmful to the environment. Take them to an  
approved disposal point.  
Reinitialising the remote  
control  
Following replacement of the battery or in  
the event of a fault, it may be necessary to  
reinitialise the remote control.  
Do not ingest battery.  
Chemical Burn Hazard  
This product contains a coin / button cell  
battery.  
Without Keyless Entry and Starting  
If the coin / button cell battery is swallowed,  
it can cause severe internal burns in just 2  
hours and can lead to death.  
Keep new and used batteries away from  
children.  
If the battery compartment does not close  
securely, stop using the product and keep it  
away from children.  
If you think batteries might have been  
swallowed or placed inside any part of the  
body, seek immediate medical attention.  
► Insert the mechanical key (incorporated into  
the remote control) into the lock to open the  
vehicle.  
► Place the electronic key against the back-up  
reader on the steering column and hold it there  
until the ignition is switched on.  
► With a manual gearbox, place the gear lever  
in neutral then fully depress the clutch pedal.  
► With an automatic gearbox or drive  
selector, while in mode P, depress the brake  
pedal.  
► Switch the ignition off.  
34  

Related Topics

Access

Remote control / Key
Proximity Keyless Entry and Start
Central locking
Doors
Boot
Alarm
Electric windows
Sunroof