Access -> Doors for Your Peugeot 3008 SUV Third Generation (2024-2025)

Access  
If the fault persists after reinitialisation, contact  
a PEUGEOT dealer or a qualified workshop  
without delay.  
Risk of explosion or leaking of  
inflammable liquid or gas!  
Do not use in/store in/place in an environment  
where the temperature is extremely high or  
where the pressure is extremely low due to  
very high altitude.  
► Switch off the ignition and remove the key  
from the ignition switch.  
The remote control is now fully operational  
again.  
2
Doors  
With Keyless Entry and Start  
Do not try to burn, crush or cut a used battery.  
Opening  
Reinitialising the remote  
control  
Following replacement of the battery or in  
the event of a fault, it may be necessary to  
reinitialise the remote control.  
From outside  
► After unlocking the vehicle or with the  
"Keyless Entry and Start" system electronic key  
in the recognition zone, pull the door handle.  
From inside  
Without Keyless Entry and Start  
► Pull the interior opening control of a door; this  
unlocks the vehicle completely.  
With selective unlocking activated:  
– Opening the driver's door unlocks  
the driver's door only (if the vehicle has not  
already been completely unlocked).  
– Opening one of the passenger doors  
unlocks the rest of the vehicle.  
► Insert the mechanical key (incorporated into  
the remote control) into the lock to open the  
vehicle.  
► Place the electronic key against the back-up  
reader on the steering column and hold it there  
until the ignition is switched on.  
With a manual gearbox, place the gear lever  
in neutral then fully depress the clutch pedal.  
With an automatic gearbox or drive  
selector, while in mode P, depress the brake  
pedal.  
Closing  
If a door is not properly closed, this  
warning lamp comes on accompanied by  
a message if the engine is running, and an  
audible signal when the vehicle is travelling at  
more than 6 mph (10 km/h).  
► Switch the ignition off.  
► Turn the key to position 2 (Ignition on).  
► Immediately press the closed padlock button  
for a few seconds.  
► Switch on the ignition by pressing the  
"START/STOP" button.  
37